Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,214Inspections Most recent open 2026-07-16 Last loaded 2026-07-20

OSHA Inspection: MARLON SOBALVARRO

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of MARLON SOBALVARRO in 570 WILLOW VALLEY CIRCLE, BRANDON, MS 39047 (NAICS 238130). OSHA activity number 337965214.

Watch Marlon Sobalvarro — free Get an email when a new federal OSHA severe-injury report for Marlon Sobalvarro is published. One employer, no account, unsubscribe in one click.
Establishment
MARLON SOBALVARRO
Site address
570 WILLOW VALLEY CIRCLE
City
BRANDON
State
MS
ZIP
39047
Mailing
3127 GREENFIELD ROAD, PEARL, MS 39208
Inspection type
Planned (H)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
238130
Employees
3
Ownership type
A

5 citations on file for this inspection.

1926.25 A

Serious Gravity 1 3 instances 3 exposed
Issued
Penalty
Initial $1020.00 · Current $1020.00
29 CFR 1926.25(a):     During the course of construction, alteration, or repairs, form and scrap lumber with protruding nails, and all other debris, shall be kept cleared from work areas, passageways, and stairs, in and around buildings or other structures.      (a)  Construction Site - On or about December 13, 2012 employees were exposed to multiple fall and nail puncture hazards from wood boards and wood boards with nails protruding from them. Wood boards and wood boards with nails were lying all over the job site. Employees were observed walking over wood board with nails.
Recent events (1)
  • — Z (S) $1020

1926.102 A01

Serious Gravity 5 2 instances 2 exposed
Issued
Abate by
Penalty
Initial $2000.00 · Current $2000.00
29 CFR 1926.102(a)(1):     Employees shall be provided with eye and face protection equipment when machines or operations present potential eye or face injury from physical, chemical, or radiation agents.    (a) Roof Backside - On or about December 13, 2012 employees were exposed to a flying object hazard while using a nail gun.  None of the employees were wearing protection eye wear.  The employer did not provide safety glasses to his employees.
Recent events (1)
  • — Z (S) $2000

1926.300 B02

Serious Gravity 5 2 instances 2 exposed
Issued
Abate by
Penalty
Initial $2000.00 · Current $2000.00
29 CFR 1926.300(b)(2):     Belts, gears, shafts, pulleys, sprockets, spindles, drums, fly wheels, chains, or other reciprocating, rotating or moving parts of equipment shall be guarded if such parts are exposed to contact by employees or otherwise create a hazard. Guarding shall meet the requirements as set forth in American National Standards Institute, B15.1-1953 (R1958), Safety Code for Mechanical Power-Transmission Apparatus.    (a)  Rear of House - On or about December 13, 2012 employees were exposed to an amputation hazard while using an air compressor with belts and pulleys fully exposed. There was no guard to prevent employees from getting into nip point.
Recent events (1)
  • — Z (S) $2000

1926.501 B11

Serious Gravity 5 2 instances 2 exposed
Issued
Abate by
Penalty
Initial $2400.00 · Current $2400.00
29 CFR 1926.501(b)(11):     "Steep roofs." Each employee on a steep roof with unprotected sides and edges 6 feet (1.8 m) or more above lower levels shall be protected from falling by guardrail systems with toeboards, safety net systems, or personal fall arrest systems.      (a) Roof Backside - On or about December 13, 2012 employees were exposed to fall hazard while working on the 8/10 pitch roof 12 feet above the ground with no guardrail system or person fall arrest system.
Recent events (1)
  • — Z (S) $2400

1926.1053 B01

Serious Gravity 1 3 instances 3 exposed
Issued
Abate by
Penalty
Initial $1200.00 · Current $1200.00
29 CFR 1926.1053(b)(1):     When portable ladders are used for access to an upper landing surface, the ladder side rails shall extend at least 3 feet (.9 m) above the upper landing surface to which the ladder is used to gain access; or, when such an extension is not possible because of the ladder's length, then the ladder shall be secured at its top to a rigid support that will not deflect, and a grasping device, such as a grabrail, shall be provided to assist employees in mounting and dismounting the ladder. In no case shall the extension be such that ladder deflection under a load would, by itself, cause the ladder to slip off its support.      (a) Roof Backside and Roof Rightside - On or about December 13, 2012 employees were exposed to fall hazard while using three aluminum extension ladders that were not extended 3 feet above landing nor were ladders secured to building.
Recent events (1)
  • — Z (S) $1200

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 337965214.