Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,198,892Inspections Most recent open 2026-09-03 Last loaded 2026-09-07

OSHA Inspection: STUCCO-1 LLC

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of STUCCO-1 LLC in 6100 WASHINGTON AVE, RACINE, WI 53406 (NAICS 238990). OSHA activity number 338172240.

What this inspection record means

OSHA opens inspections for many reasons: routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch Stucco-1 LLC for free Get an email when a new federal OSHA severe-injury report for Stucco-1 LLC is published. One employer, no account, unsubscribe in one click.
Establishment
STUCCO-1 LLC
Site address
6100 WASHINGTON AVE
City
RACINE
State
WI
ZIP
53406
Mailing
1131 DOUGLAS, BATAVIA, IL 60510
Inspection type
Planned (H)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
Non-union (B)
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
238990
Employees
6
Ownership type
Private (A)

5 citations on file for this inspection.

1926.451 F03

Serious Gravity 10 1 instance 2 exposed
Issued
Feb 7, 2013
Abate by
Feb 13, 2013
Penalty
Initial $2,800 · Current $2,800
29 CFR 1926.451(f)(3):     Scaffolds and scaffold components shall be inspected for visible defects by a competent person before each work shift, and after any occurrence which could affect a scaffold's structural integrity.      (a)  The scaffold and scaffold components employees were working from was not inspected by a competent person for visible defects prior to the work shift.
Recent events (2)
  • · I (S) $2800
  • · Z (S) $2800

1926.451 E01

Serious Gravity 10 1 instance 1 exposed
Issued
Feb 7, 2013
Abate by
Feb 13, 2013
Penalty
Initial $2,800 · Current $0 Reduced
29 CFR 1926.451(e)(1): When scaffold platforms are more than 2 feet (0.6 m) above or below a point of access, portable ladders, hook-on ladders, attachable ladders, stair towers (scaffold stairways/towers), stairway-type ladders (such as ladder stands), ramps, walkways, integral prefabricated scaffold access, or direct access from another scaffold, structure, personnel hoist, or similar surface shall be used. Crossbraces shall not be used as a means of access.    (a)  Employees were accessing the scaffold work platforms by climbing the scaffold uprights and cross braces.  This exposed employees to fall hazards.
Recent events (2)
  • · I (S) $0
  • · Z (S) $2800

1926.451 B01

Serious Gravity 10 1 instance 2 exposed
Issued
Feb 7, 2013
Abate by
Feb 13, 2013
Penalty
Initial $2,800 · Current $0 Reduced
29 CFR 1926.451(b)(1): Each platform on all working levels of scaffolds shall be fully planked or decked between the front uprights and the guardrail supports.    (a)  Platforms at working levels of the scaffold were not fully planked between the front uprights and the guardrail supports, exposing employees to a fall hazard of approximately 33 feet.
Recent events (2)
  • · I (S) $0
  • · Z (S) $2800

1926.451 C01

Serious Gravity 5 1 instance 2 exposed
Issued
Feb 7, 2013
Abate by
Feb 13, 2013
Penalty
Initial $2,000 · Current $2,000
29 CFR 1926.451(c)(1):     Supported scaffolds with a height to base width (including outrigger supports, if used) ratio of more than four to one (4:1) shall be restrained from tipping by guying, tying, bracing, or equivalent means.    (a)  The supported scaffold with a greater than a 4:1 height to base width ratio was not tied, guyed or braced to prevent tipping.  This exposed employees to a fall hazard of approximately 33 feet.
Recent events (2)
  • · I (S) $2000
  • · Z (S) $2000

1926.451 G04 IV

Other-than-serious 1 instance 2 exposed
Issued
Feb 7, 2013
Abate by
Feb 13, 2013
Penalty
Initial $2,000 · Current $0 Reduced
29 CFR 1926.451(g)(4)(iv):     When midrails are used, they shall be installed at a height approximately midway between the top edge of the guardrail system and the platform surface.    (a)  Midrails were not installed between the top edge of the guardrail system and the working platform surface. This exposed employees to a fall hazard of approximately 33 feet.
Recent events (2)
  • · I (O) $0
  • · Z (S) $2000

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). OSHA publishes its own view of this case as inspection number 338172240.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.