DENMARK, WI ·
OSHA Inspection: D C STEINLE INC
Complaint inspection · Safety discipline
At a glance
On , OSHA opened a complaint safety inspection of D C STEINLE INC in 5744 LANGES CORNERS RD, DENMARK, WI 54208 (NAICS 236220). OSHA activity number 338827835.
OSHA opens inspections for many reasons: routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- D C STEINLE INC
- Site address
- 5744 LANGES CORNERS RD
- City
- DENMARK
- State
- WI
- ZIP
- 54208
- Mailing
- 6907 ROCKY RUN DRIVE, RUDOLPH, WI 54475
What kind of inspection was it?
- Inspection type
- Complaint (B)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- Non-union (B)
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 236220
- Employees
- 4
- Ownership type
- Private (A)
Citations
4 citations on file for this inspection.
1926.404 B01 I
- Issued
- Apr 15, 2013
- Abate by
- Jun 4, 2013
- Penalty
- Initial $2,800 · Current $1,400 Reduced
General-duty citation text
29 CFR 1926.404(b)(1)(i): Employer did not use either ground fault circuit interrupters as specified in paragraph (b)(1)(ii) of this section, or an assured equipment grounding conductor program as specified in paragraph (b)(1)(iii) of this section to protect employees on construction sites: a) Employer did not provide ground-fault protection for employees who were utilizing electrical equipment for temporary power; 120V power supplied from permanent wiring receptacle through extension cords to hand held tools without GFCI device or Assured Equipment Grounding Conductor Program. ABATEMENT DOCUMENTATION AND ABATEMENT CERTIFICATION REQUIRED
Recent events (2)
- · I (S) $1400
- · Z (S) $2800
1926.404 F06
- Issued
- Apr 15, 2013
- Abate by
- May 31, 2013
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1926.404(f)(6): The path to ground from circuits, equipment, or enclosures was not permanent and continuous: a) On 02-12-13, an employee who was using temporary power for a hand held power drill was utilizing a 100 ft. extension cord without the ground pin. ABATEMENT DOCUMENTATION AND ABATEMENT CERTIFICATION REQUIRED
Recent events (2)
- · I (S) $0
- · Z (S) $0
1926.405 G02 III
- Issued
- Apr 15, 2013
- Abate by
- May 31, 2013
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1926.405(g)(2)(iii): Flexible cords were not used in continuous lengths without splice or tap: a) On 02-12-13, employees were utilizing a 14 gauge, 100 ft. extension cord with two splices for temporary power to electric hand tools. b) On 02-12-13, employees were utilizing a 14 gauge, greater than 125 ft. extension cord with three splices for temporary power to electric hand tools. c) On 02-12-13, employees were utilizing a 16 gauge, 100 ft. extension cord with four splices for temporary power to electric hand tools. d) On 02-12-13, employees were utilizing a Bosch circular saw with a splice in the flexible cord. ABATEMENT CERTIFICATION REQUIRED
Recent events (2)
- · I (S) $0
- · Z (S) $0
1926.416 E01
- Issued
- Apr 15, 2013
- Abate by
- May 31, 2013
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1926.416(e)(1): Worn or frayed electric cords or cables were used: a) On 02-12-13, employees were utilizing a 16 gauge, 100 ft. extension cord with three frays for temporary power to hand tools. b) On 02-12-13, employees were utilizing a 12 gauge, 100 ft. extension cord with a worn and frayed cord at the point of connection to the female end for temporary power. ABATEMENT CERTIFICATION REQUIRED.
Recent events (2)
- · I (S) $0
- · Z (S) $0
More inspections in this industry (NAICS 236220)
More inspections in WI
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). OSHA publishes its own view of this case as inspection number 338827835.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.