Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,197,549Inspections Most recent open 2026-08-27 Last loaded 2026-08-31

OSHA Inspection: R. TANNER CONSTRUCTION COMPANY, INC.

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of R. TANNER CONSTRUCTION COMPANY, INC. in 465 COLUMBIA DR., MARIETTA, GA 30064 (NAICS 238130). OSHA activity number 338908585.

What this inspection record means

OSHA opens inspections for many reasons: routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch R. Tanner Construction Company, INC. for free Get an email when a new federal OSHA severe-injury report for R. Tanner Construction Company, INC. is published. One employer, no account, unsubscribe in one click.
Site address
465 COLUMBIA DR.
City
MARIETTA
State
GA
ZIP
30064
Mailing
6772 GLADE RD., ACWORTH, GA 30102
Inspection type
Planned (H)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
Non-union (B)
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
238130
Employees
7
Ownership type
Local government (B)

5 citations on file for this inspection.

1926.501 B13

Serious Gravity 10 1 instance 5 exposed
Issued
May 31, 2013
Abate by
Jun 26, 2013
Penalty
Initial $2,800 · Current $1,680 Reduced
29 CFR 1926.501(b)(13): Each employee engaged in residential construction activities 6 feet or more above lower levels was not protected by guardrail systems, safety net system, or personal fall arrest system, or an alternative fall protection measure that meets a provision described in paragraph (b) of 29 CFR 1926.501.   a) 465 Columbia Drive - Employees performing residential framing activities were exposed to lower level fall hazards of over 25 feet, as there was no means of approved fall protection in use.
Recent events (2)
  • · I (S) $1680
  • · Z (S) $2800

1926.451 G01 VII

Serious Gravity 5 1 instance 1 exposed
Issued
May 31, 2013
Abate by
Jun 26, 2013
Penalty
Initial $0 · Current $0
29 CFR 1926.451(g)(1)(vii): Each employee on a scaffold, not otherwise specified in paragraphs (g)(1)(i) through (g)(1)(vi) of this section, more than 10 feet (3.1 m) above lower level was not protected from falls by the use of personal fall arrest systems or guardrail systems meeting the requirements of paragraph (g)(4) of this section.  a) 465 Columbia Drive - The employer exposed an employee to a lower level fall hazard of approximately 11 feet while working from a carpenters' bracket scaffold platform.  The employee was not using any means of approved fall protection.
Recent events (2)
  • · I (S) $0
  • · Z (S) $0

1926.452 G01

Serious Gravity 5 1 instance 1 exposed
Issued
May 31, 2013
Abate by
Jun 26, 2013
Penalty
Initial $0 · Current $0
29 CFR 1926.452(g)(1): 29 CFR 1926.452(g)(1): Each bracket, for carpenters' bracket scaffolds was not attached to the structure by a bolt extending through to the opposite side of the structure's wall.  a) 465 Columbia Drive - The employer exposed an employee to a lower level fall hazard of approximately 11 feet while working from a carpenters' bracket scaffold that did not have its brackets attached with bolts extending through the side of the structure.
Recent events (2)
  • · I (S) $0
  • · Z (S) $0

1926.503 A01

Serious Gravity 10 1 instance 5 exposed
Issued
May 31, 2013
Abate by
Jun 26, 2013
Penalty
Initial $2,800 · Current $1,680 Reduced
29 CFR 1926.503(a)(1): The employer did not provide a training program for each employee potentially exposed to fall hazards to enable each employee to recognize the hazards of falling and the procedures to be followed in order to minimize these hazards:  a) 465 Columbia Drive - The employer did not provide a program to train employees exposed to lower level fall hazards on the recognition of fall hazards and how eliminate the hazards.
Recent events (2)
  • · I (S) $1680
  • · Z (S) $2800

1926.454 A

Serious Gravity 5 1 instance 1 exposed
Issued
May 31, 2013
Abate by
Jun 26, 2013
Penalty
Initial $0 · Current $0
29 CFR 1926.454(a): The employer did not have each employee who performed work while on a scaffold trained by a person qualified in the subject matter to recognize the hazards associated with the type of scaffold being used and to understand the procedures to control or minimize those hazards.  a) 465 Columbia Drive - The employer exposed an employee to a lower level fall hazard while working from a carpenters' bracket scaffold.  The employee had not been trained to recognize scaffold hazards and how to eliminate the hazards.
Recent events (2)
  • · I (S) $0
  • · Z (S) $0

View R. Tanner Construction Company, INC.'s full OSHA safety record →

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). OSHA publishes its own view of this case as inspection number 338908585.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.