Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,992Inspections Most recent open 2026-07-18 Last loaded 2026-07-22

OSHA Inspection: BARLO SIGNS

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of BARLO SIGNS in 850 BALD HILL RD, WARWICK, RI 02886 (NAICS 339950). OSHA activity number 338909567.

What this inspection record means

OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch Barlo Signs — free Get an email when a new federal OSHA severe-injury report for Barlo Signs is published. One employer, no account, unsubscribe in one click.
Establishment
BARLO SIGNS
Site address
850 BALD HILL RD
City
WARWICK
State
RI
ZIP
02886
Mailing
158 GREELEY ST, HUDSON, NH 03051
Inspection type
Planned (H)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
339950
Employees
60
Ownership type
A

6 citations on file for this inspection.

1926.404 B01 II

Other-than-serious 1 instance 3 exposed
Issued
Mar 11, 2013
Abate by
Mar 26, 2013
Penalty
Initial $3,080 · Current $500 Reduced
29 CFR 1926.404(b)(1)(ii):     On a construction site, where an assured equipment grounding program was not utilized, all 120-volt, single-phase, 15 and 20 ampere receptacle outlets which were not a part of the permanent wiring of the building or structure and which were in use by employees did not have approved ground-fault circuit interrupers for personnel protection:    (a) Jobsite: The 120 volt receptacles of the Miller Bobcat 225 10 kW Welder/Generator in use powering equipment on the jobsite did not have approved ground-fault circuit interrupers for personnel protection, for a jobsite located in Warwick RI on or about 2-14-13.
Recent events (2)
  • — I (O) $500
  • — Z (S) $3080

1926.501 B01

Serious Gravity 10 1 instance 1 exposed
Issued
Mar 11, 2013
Abate by
Mar 26, 2013
Penalty
Initial $5,390 · Current $3,000 Reduced
29 CFR 1926.501(b)(1):     Each employee on a walking/working surface with an unprotected side or edge which was 6 feet (1.8 m) or more above a lower level was not protected from falling by the use of guardrail systems, safety net systems, or personal fall arrest systems:    (a) Jobsite: An employee working on the roof installing a sign, exposed to a fall of approximately 20 feet, was not protected from falling by the use of guardrail systems, safety net systems, or personal fall arrest systems, for a jobsite located in Warwick RI on or about 2-14-13.
Recent events (2)
  • — I (S) $3000
  • — Z (S) $5390

1926.1417 C01

Other-than-serious 1 instance 3 exposed
Issued
Mar 11, 2013
Abate by
Mar 26, 2013
Penalty
Initial $2,310 · Current $500 Reduced
29 CFR 1926.1417(c)(1):     The procedures applicable to the operation of the equipment, including rated capacities (load charts), recommended operating speeds, special hazard warnings, instructions, and operator's manual, were not readily available in the cab at all times for use by the operator:    (a) Jobsite: The operator's manual of the Elliott H70F hydraulic truck crane, truck T76, was not readily available in the cab at all times for use by the operator, for a jobsite located in Warwick RI on or about 2-14-13.
Recent events (2)
  • — I (O) $500
  • — Z (S) $2310

1926.1412 D01 V

Other-than-serious 1 instance 3 exposed
Issued
Mar 11, 2013
Abate by
Mar 26, 2013
Penalty
Initial $3,080 · Current $500 Reduced
29 CFR 1926.1412(d)(1)(v):     The employer did not inspect hooks and latches for deformation, cracks, excessive wear, or damage such as from chemicals or heat:    (a) Jobsite: The employer did not inspect the latch of the hook on the Elliott H70F hydraulic truck crane, truck T76, for deformation and excessive wear in that the latch was defective and not operational, for a jobsite located in Warwick RI on or about 2-14-13.
Recent events (2)
  • — I (O) $500
  • — Z (S) $3080

1926.503 B01

Other-than-serious 1 instance 1 exposed
Issued
Mar 11, 2013
Abate by
Mar 26, 2013
Penalty
Initial $0 · Current $0
29 CFR 1926.503(b)(1):     The employer did not verify fall protection training by preparing a written certification record:    (a) Jobsite: The employer did not verify fall protection training for employees working at heights by preparing a written certification record, for a jobsite located in Warwick RI on or about 2-14-13.
Recent events (2)
  • — I (O) $0
  • — Z (O) $0

1926.1412 E03 II

Other-than-serious 1 instance 3 exposed
Issued
Mar 11, 2013
Abate by
Mar 26, 2013
Penalty
Initial $770 · Current $300 Reduced
29 CFR 1926.1412(e)(3)(ii):     The documentation of the monthly inspection was not retained for a minimum of three months:    (a) Jobsite: The documentation of the monthly inspection of the Elliott H70F hydraulic truck crane, truck T76, as required by 29 CFR 1926.1412(e)(1), was not retained with the crane for a period of three months and was not made available to OSHA on or about 2-14-13.
Recent events (2)
  • — I (O) $300
  • — Z (O) $770

View Barlo Signs's full OSHA safety record →

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 338909567.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.