Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,992Inspections Most recent open 2026-07-18 Last loaded 2026-07-22

OSHA Inspection: JOE MAGGIO, LLC

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of JOE MAGGIO, LLC in US ROUTE 46 EAST, DENVILLE, NJ 07834 (NAICS 238140). OSHA activity number 338920226.

What this inspection record means

OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch JOE Maggio, LLC — free Get an email when a new federal OSHA severe-injury report for JOE Maggio, LLC is published. One employer, no account, unsubscribe in one click.
Establishment
JOE MAGGIO, LLC
Site address
US ROUTE 46 EAST
City
DENVILLE
State
NJ
ZIP
07834
Mailing
PO BOX 561, SUSSEX, NJ 07461
Inspection type
Planned (H)
Scope
Complete (A)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
238140
Employees
10
Ownership type
A

4 citations on file for this inspection.

1926.20 B01

Serious Gravity 5 1 instance 3 exposed
Issued
Apr 5, 2013
Abate by
May 22, 2013
Penalty
Initial $2,200 · Current $2,200
29 CFR 1926.20(b)(1): The employer did not initiate and maintain such programs as may be necessary to comply with this part:    a) U.S. Route 46 East, Denville, NJ.    Employer did not develop an accident prevention program, thereby exposing his employees to hazards including but not limited to falls. The employees were not provided, nor were they made to wearing or use fall protection.                                       Violation observed on or 02/25/2013.
Recent events (2)
  • — I (S) $2200
  • — Z (S) $2200

1926.1060 A

Serious Gravity 5 1 instance 1 exposed
Issued
Apr 5, 2013
Penalty
Initial $0 · Current $0
29 CFR 1926.1060(a): The employer did not provide a training program for each employee using ladders and stairways, as necessary, which would train each employee in the procedures to be followed to minimize hazards related to ladders and stairways:    a)  U.S. Route 46 East, Denville, NJ.    Training on the proper use of step ladder and the hazards associated with their placement and use, was not provided to employee on this jobsite by a competent person.                                           Violation observed on or about 02/25/2013.
Recent events (2)
  • — I (S) $0
  • — Z (S) $0

1926.501 B10

Serious Gravity 10 1 instance 3 exposed
Issued
Apr 5, 2013
Penalty
Initial $3,080 · Current $3,080
29 CFR 1926.501(b)(10): Each employee engaged in roofing activities on low-slope roofs with unprotected sides and edges 6 feet or more above lower levels, was not protected from falling by guardrail systems, safety net systems, personal fall arrest systems, or a combination of warning line system and guardrail system, warning line system and safety net system, or warning line system and personal fall arrest system, or warning line system and safety monitoring system.  Or, on roofs 50-feet (15.25 m) or less in width, each employee was not protected by use of a monitoring system:    a)  U.S. Route 46 East, Denville, NJ.    Employees working low-slope roof laying cement block was not protected from fall the next lower level by guardrali system, safety net system, and personal fall arrest system, thereby exposing the employees to a fall hazard of approximately 15 feet to the ground below.                                                Violation observed on or about 02/25/2013.
Recent events (2)
  • — I (S) $3080
  • — Z (S) $3080

1926.1053 B01

Repeat Gravity 5 1 instance 1 exposed
Issued
Apr 5, 2013
Abate by
Apr 5, 2013
Penalty
Initial $11,000 · Current $2,868 Reduced
29 CFR 1926.1053(b)(1): Where a step ladder was used for access to an upper level landing surface and the ladder length did not allow the ladder side rails to extend at least 3 feet (0.9 m) above the upper landing surface being accessed, the ladder was not secured at its top to a rigied support that will not deflect, and/or a grasping device was not provided to assist emmployees in mounting and dismounting the ladder:    a)  U.S. Route 46 East, Denville, NJ.    Employee egress from tubular frame scaffold step on the top rung of a step ladder that did not go 3 feet above upper landing surface, thereby exposing the employee to a 6 feet fall hazard to the ground.                                         Violation observed on or about 02/25/2013.    Joe Maggio, LLC was previously cited for a violation of this Occupational Safety and Health or its equivalent 29 CFR 1926.1053(b)(1) which was contained in OSHA Inspection Number 313753824, Citation Number 2, Item Number 1, with a final order issued on 01/13/2010 with respect  to a workplace located at 5 Bowling Green Parkway, Lake Hopatcong, NJ.    Joe Maggio, LLC was previously cited for a Violation of this Occupational Safety and Health or its equivalent 29 CFR 1926.1053(b)(1) which was contained in OSHA Inspection Number 312272420, Citation Number 1, Item Number 1 with a final order issued on 10/22/2008 with respect to a workplace located at 1481 Route 23 Butler, NJ.
Recent events (2)
  • — I (R) $2868
  • — Z (R) $11000

View JOE Maggio, LLC's full OSHA safety record →

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 338920226.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.