Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,992Inspections Most recent open 2026-07-18 Last loaded 2026-07-22

OSHA Inspection: BRADLEY CONSTRUCTION COMPANY INC.

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of BRADLEY CONSTRUCTION COMPANY INC. in 5204 SHERRIER PL, WASHINGTON, DC 20011 (NAICS 236115). OSHA activity number 338967979.

What this inspection record means

OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch Bradley Construction Company INC. — free Get an email when a new federal OSHA severe-injury report for Bradley Construction Company INC. is published. One employer, no account, unsubscribe in one click.
Site address
5204 SHERRIER PL
City
WASHINGTON
State
DC
ZIP
20011
Mailing
11515 MOUNTAIN VIEW ROAD, DAMASCUS, MD 20872
Inspection type
Planned (H)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
236115
Employees
9
Ownership type
A

4 citations on file for this inspection.

1926.404 B01 II

Other-than-serious 3 instances 3 exposed
Issued
May 13, 2013
Abate by
May 13, 2013
Penalty
Initial $1,600 · Current $800 Reduced
29 CFR 1926.404(b)(1)(ii): 29 CFR 1926.404(b)(1)(ii): On a construction site, where an assured equipment grounding program was not utilized, all 120-volt, single-phase, 15 and 20 ampere receptacle outlets which were not a part of the permanent wiring of the building or structure and which are in use by employees did not have approved ground fault circuit interrupters for personal protection:     a) On or about March 1, 2013; first floor; subcontracted employees were using portable electrical equipment, such as but not limited to circular saws, that were plugged into outlets either directly or by portable extension cords which were not equipped with a ground fault circuit interrupter.     For the purposes of this inspection, the employer was determined to be the controlling and correcting employer of the jobsite. The employer is being cited under OSHA's Multi-Employer Workplace Policy.
Recent events (2)
  • — I (O) $800
  • — Z (S) $1600

1926.405 B02

Other-than-serious 3 instances 3 exposed
Issued
May 13, 2013
Abate by
Jun 7, 2013
Penalty
Initial $1,600 · Current $800 Reduced
29 CFR 1926.405(b)(2): All pull boxes, junction boxes, and fittings were not provided with covers:     a) On or about March 1, 2013; first floor; subcontracted employees were using unguarded energized outlets either plugged in directly or by portable extension cords to power electrical equipment, such as but not limited to saws and portable lighting.     Abatement certification required within 10 days after abatement date. The certification shall include a statement that abatement is complete, date and method of abatement, and states employees and their representatives were informed of this abatement.      For the purposes of this inspection, the employer was determined to be the controlling and correcting employer of the jobsite. The employer is being cited under OSHA's Multi-Employer Workplace Policy.
Recent events (2)
  • — I (O) $800
  • — Z (S) $1600

1926.501 B13

Serious Gravity 10 3 instances 4 exposed
Issued
May 13, 2013
Abate by
May 13, 2013
Penalty
Initial $2,800 · Current $1,400 Reduced
29 CFR 1926.501(b)(13): Each employee engaged in residential construction activities 6 feet (1.8 m)  or more above lower levels was not protected by guardrail systems, safety net systems, personal fall arrest systems, or an alternative fall protection measure under another provision of paragraph 1926.501 (b), nor did the employer demonstrate that it is infeasible or creates a greater hazard to use these systems and develop and implement a fall protection plan which meets the requirements of paragraph (k) of section 1926.502:     a) On or about March 1, 2013; roof area north, subcontracted employees were observed working on a 10 in 12 pitch roof of a two story residential home without a personal fall arrest system in place to prevent them from falling 30-35 feet to ground level.       b) On or about March 1, 2013; throughout the second floor, subcontracted employees were also observed working around open working/walking surfaces within the residential construction that were not properly guarded by a guard rail system; exposing them to a 12 foot fall to the lower level.     c) On or about March 1, 2013; throughout the site, subcontracted employees were working around wall openings that were not properly guarded to protect them from falling 15 feet to ground level.      For the purposes of this inspection, the employer was determined to be the controlling and correcting employer of the jobsite. The employer is being cited under OSHA's Multi-Employer Workplace Policy.
Recent events (2)
  • — I (S) $1400
  • — Z (S) $2800

1926.1053 B01

Serious Gravity 5 1 instance 3 exposed
Issued
May 13, 2013
Abate by
Jun 7, 2013
Penalty
Initial $2,000 · Current $1,000 Reduced
29 CFR 1926.1053(b)(1): Where (a) portable ladder(s) was/were used for access to an upper level landing surface and the ladder's length did not allow the ladder side rails to extend at least 3 feet (0.9 m) above the upper landing surface being accessed, the ladder was not secured at its top to a rigged support that will not deflect, and/or a grasping device was not provided to assist employees in mounting and dismounting the ladder:     a) On or about March 1, 2013; second floor; subcontracted employees were using a step ladder that did not extended 3 feet above the landing to access the working platform to install the trusses.      For the purposes of this inspection, the employer was determined to be the controlling and correcting employer of the jobsite. The employer is being cited under OSHA's Multi-Employer Workplace Policy.     Abatement certification required within 10 days after abatement date. The certification shall include a statement that abatement is complete, date and method of abatement, and states employees and their representatives were informed of this abatement.
Recent events (2)
  • — I (S) $1000
  • — Z (S) $2000

View Bradley Construction Company INC.'s full OSHA safety record →

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 338967979.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.