HIRAM, GA —
OSHA Inspection: JULIO RAMIREZ
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of JULIO RAMIREZ in 17 HIGH POINT WAY, HIRAM, GA 30141 (NAICS 238130). OSHA activity number 339144495.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- JULIO RAMIREZ
- Site address
- 17 HIGH POINT WAY
- City
- HIRAM
- State
- GA
- ZIP
- 30141
- Mailing
- 730 FRANKLIN ROAD, APT. E8, MARIETTA, GA 30067
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- B
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 238130
- Employees
- 3
- Ownership type
- A
Citations
5 citations on file for this inspection.
1926.451 B02
- Issued
- Jul 25, 2013
- Penalty
- Initial $2,800 · Current $2,800
General-duty citation text
29 CFR 1926.451(b)(2): Except as provided in paragraphs (b)(2)(i) and (b)(2)(ii) of this section, each scaffold platform and/or walkway was not at least 18 inches (46 cm) wide: (a) Front side, new residential construction located at 17 High Point Way, Hiram, GA 30141: Employee framing a roof from a job-made scaffold was exposed to falls of approximately 14-feet, 10-inches while working on a 2x10 wood plank which measured 9 1/2-inches wide.
Recent events (1)
- — Z (S) $2800
1926.451 G01
- Issued
- Jul 25, 2013
- Penalty
- Initial $2,800 · Current $2,800
General-duty citation text
29 CFR 1926.451(g)(1): Each employee on a scaffold more than 10 feet above a lower level were not protected from falling to that lower level. (a) Front side, new residential construction located at 17 High Point Way, Hiram, GA 30141: Employees were exposed to falls of approximately 14-feet, 10-inches while working on a job-made scaffold platform engaged in framing activities with no fall protection system in place.
Recent events (1)
- — Z (S) $2800
1926.454 A
- Issued
- Jul 25, 2013
- Abate by
- Aug 6, 2013
- Penalty
- Initial $2,800 · Current $2,800
General-duty citation text
29 CFR 1926.454(a): The employer did not have each employee who performed work while on a scaffold trained by a person qualified in the subject matter to recognize the hazards associated with the type of scaffold being used and to understand the procedures to control or minimize those hazards. (a) Front side, new residential construction located at 17 High Point Way, Hiram, GA 30141: Employees exposed to fall hazards of 14-feet, 10-inches were not trained by a competent person to recognize hazards associated with the job-made scaffold system being used on site.
Recent events (1)
- — Z (S) $2800
1926.1052 C01 II
- Issued
- Jul 25, 2013
- Penalty
- Initial $1,600 · Current $1,600
General-duty citation text
29 CFR 1926.1052(c)(1)(ii): Stairways having four or more risers or rising more than 30 inches (76 cm), whichever is less, were not equipped with a stairrail system along each unprotected side or edge: (a) Stairway, new residential construction located at 17 High Point Way, Hiram, GA 30141: Employees were exposed to fall hazards while using a stairway which was 12 risers high and was not equipped with a handrail to provide employees with a handhold for support while accessing upper and lower levels.
Recent events (1)
- — Z (S) $1600
1926.404 F06
- Issued
- Jul 25, 2013
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1926.404(f)(6): The path to ground from circuits, equipment, or enclosures was not permanent and continuous: (a) Temporary electrical service, new residential construction located at 17 High Point Way, Hiram, GA 30141: Employees used a 50-foot yellow extension/flexible cord which was missing a ground pin to power a Makita (Model 50007F) 7 1/4-inch Circular Saw.
Recent events (1)
- — Z (O) $0
More inspections at Julio Ramirez
View Julio Ramirez's full OSHA safety record →
More inspections in this industry (NAICS 238130)
More inspections in GA
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 339144495.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.