KANSAS CITY, MO —
OSHA Inspection: TURNKEY CONSTRUCTION
Referral inspection · Safety discipline
At a glance
On , OSHA opened a referral safety inspection of TURNKEY CONSTRUCTION in 7901 E 24 HSY, KANSAS CITY, MO 64125 (NAICS 238120). OSHA activity number 339152217.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- TURNKEY CONSTRUCTION
- Site address
- 7901 E 24 HSY
- City
- KANSAS CITY
- State
- MO
- ZIP
- 64125
- Mailing
- 8131 LONGVIEW RD, LENEXA, KS 66220
What kind of inspection was it?
- Inspection type
- Referral (C)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- B
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 238120
- Employees
- 15
- Ownership type
- A
Citations
8 citations on file for this inspection.
1926.451 A01
- Issued
- Jul 18, 2013
- Penalty
- Initial $2,520 · Current $0 Reduced
General-duty citation text
29 CFR 1926.451(a)(1): Each scaffold and/or scaffold component was not capable of supporting, without failure, its own weight and at least 4 times the maximum intended load applied or transmitted to it:Note: Exceptions are provided in paragraphs (a)(2), (a)(3), (a)(4), (a)(5) and (g) of this section. On June 26, 2013 at the jobsite located at or near 7901 E 24 Highway in Kansas City, MO employees were exposed to a fall hazard in that they were working from a scaffold that was not capable of supporting its own weight and at least 4 times the maximum intended load applied or transmitted to it.
Recent events (2)
- — I (S) $0
- — Z (S) $2520
1926.502 B01
- Issued
- Jul 18, 2013
- Penalty
- Initial $1,224 · Current $0 Reduced
General-duty citation text
29 CFR 1926.502(b)(1): The top edge height of the top rails, or equivalent guardrail system members, was not 42 inches (1.1 m) plus or minus 3 inches (8 cm) above the walking/working level:Note: When employees are using stilts, the top edge height of the top rail, or equivalent member, shall be increased an amount equal to the height of the stilts. On June 26, 2013 at the jobsite located at or near 7901 East 24 Highway in Kansas City, MO, employees were exposed to a fall hazard in that the top rail height of guard rail system was not 42 inches plus or minus 3 inches above walking/working level.
Recent events (2)
- — I (S) $0
- — Z (S) $1224
1926.502 B02
- Issued
- Jul 18, 2013
- Penalty
- Initial $1,224 · Current $1,224
General-duty citation text
29 CFR 1926.502(b)(2): Midrails, screens, mesh, intermediate vertical members, or equivalent intermediate structure members were not installed between the top edge of the guardrail system and the walking/working surface when there was no wall or parapet wall at least 21 inches (53 cm) high. On June 26, 2013 at the jobsite located at or near 7901 E 24 Highway in Kansas City, MO, employees were exposed to a fall hazard in that guardrail systems on site did not have midrails installed.
Recent events (2)
- — I (S) $1224
- — Z (S) $1224
1926.502 B11
- Issued
- Jul 18, 2013
- Penalty
- Initial $1,224 · Current $1,224
General-duty citation text
29 CFR 1926.502(b)(11): When guardrail systems are used at holes, they shall be erected on all unprotected sides or edges of the hole. On June 26, 2013 at the jobsite located at or near 7901 E 24 Highway in Kansas City, MO, employees were exposed to a fall hazard in that a guardrail system was not erected on all sides of a hole.
Recent events (2)
- — I (S) $1224
- — Z (S) $1224
1926.502 D06 I
- Issued
- Jul 18, 2013
- Penalty
- Initial $1,530 · Current $0 Reduced
General-duty citation text
29 CFR 1926.502(d)(6)(i): A snaphook was engaged (i) directly to webbing, rope or wire rope; (ii) to each other (iii) to a Dee-ring to which another snaphook or other connector is attached;(iv) to a horizontal lifeline; or (v) to any objectwhich is incompatibly shaped or dimensioned in relation to the snaphook such that unintentional disengagement could occur by the connected object being able to depress the snaphook keeper and release itself. On June 26, 2013 at the jobsite located at or near 7901 E 24 Highway, in Kansas City, MO, employees were exposed to a fall hazard in that the snaphook used was not designed for the connection it was used with.
Recent events (2)
- — I (S) $0
- — Z (S) $1530
1926.502 D17
- Issued
- Jul 18, 2013
- Penalty
- Initial $1,224 · Current $0 Reduced
General-duty citation text
29 CFR 1926.502(d)(17): The attachment point of the body belt was not located in the center of the wearer's back. The attachment point of the body narness was not located in the center of the wearer's back near shoulder level, or above the wearer's head. On June 26, 2013 at the jobsite located at 7901 East 24 Highway in Kansas City, MO, employee was exposed to a hazard in that the attachment point of his body harness was not located in the center of his back near shoulder level.
Recent events (2)
- — I (S) $0
- — Z (S) $1224
1926.760 A01
- Issued
- Jul 18, 2013
- Penalty
- Initial $2,520 · Current $0 Reduced
General-duty citation text
29 CFR 1926.760(a)(1): Each employee engaged in a steel erection activity who is on a walking/working surface with an unprotected side or edge more than 15 feet (4.6 m) above a lower level was not protected from fall hazards by guardrail systems, safety net systems, personal fall arrest systems, positioning device systems, or fall restraint systems. On June 26, 2013 at the jobsite locate at or near 7901 E 24 Highway in Kansas City, Mo, employees were exposed to a fall hazard in that they were engaged in steel erection work more than 15 feet above a lower level without an approved form of fall protection.
Recent events (2)
- — I (S) $0
- — Z (S) $2520
1926.1053 B01
- Issued
- Jul 18, 2013
- Penalty
- Initial $1,040 · Current $1,040
General-duty citation text
29 CFR 1926.1053(b)(1): Where portable ladders were used for access to an upper landing surface and the ladders length allows, the ladder side rails did not extend at least 3 feet (.9 m) above the upper landing surface being accessed: On June 26, 2013 at the jobsite located at or near 7901 E 24 Highway in Kansas City, MO employees were exposed to a fall hazard in that ladders used to access upper landing surfaces did not extend 3 feet above the upper landing surface.
Recent events (2)
- — I (S) $1040
- — Z (S) $1040
More inspections at Turnkey Construction
View Turnkey Construction's full OSHA safety record →
More inspections in this industry (NAICS 238120)
More inspections in MO
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 339152217.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.