NEWBURGH HEIGHTS, OH —
OSHA Inspection: ARCELORMITTAL USA
Complaint inspection · Safety discipline
At a glance
On , OSHA opened a complaint safety inspection of ARCELORMITTAL USA in 1555 HARVARD AVE., NEWBURGH HEIGHTS, OH 44105 (NAICS 331111). OSHA activity number 339164089.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- ARCELORMITTAL USA
- Site address
- 1555 HARVARD AVE.
- City
- NEWBURGH HEIGHTS
- State
- OH
- ZIP
- 44105
- Mailing
- 3060 EGGERS ROAD, CLEVELAND, OH 44105
What kind of inspection was it?
- Inspection type
- Complaint (B)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- A
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 331111
- Employees
- 1850
- Ownership type
- A
Citations
5 citations on file for this inspection.
1910.22 A01
- Issued
- Dec 16, 2013
- Penalty
- Initial $2,550 · Current $1,530 Reduced
General-duty citation text
29 CFR 1910.22(a)(1): Places of employment, passageways, storerooms, and service rooms were not kept clean and orderly and in a sanitary condition. On or before July 3, 2013, the employer did not ensure that floor openings were effectively guarded. The unguarded floor holes or openings were located in the following areas: On and before July 03/2013 the employer did not ensure that floor openings were effectively guarded. The unguarded floor holes or openings were located in the following areas: a. The trenches dug in the flooring of the annealing department basement. b. Holes in the flooring around sump pump 1 and 2, in the annealing department basement. c. A three foot wide opening created when the pump of the hot well motor was removed.
Recent events (3)
- — F (O) $1530
- — C (S) $2550
- — Z (S) $2550
1910.305 A02 X
- Issued
- Dec 16, 2013
- Penalty
- Initial $4,250 · Current $0 Reduced
General-duty citation text
29 CFR 1910.305(a)(2)(x): Flexible cords and cables were not protected from accidental damage. The flexible (electrical) cable wire that entered into the 480 volt distribution cabinets, located in the basement of the Annealing department, was not installed in a neat workman like manner and was not protected from accidental damage.
Recent events (3)
- — F (S) $0
- — C (S) $4250
- — Z (S) $4250
1910.305 E01
- Issued
- Dec 16, 2013
- Penalty
- Initial $0 · Current $1,530
General-duty citation text
29 CFR 1910.305(e)(1): Cabinets, cutout boxes, fittings, boxes, and panel-board enclosures in damp or wet locations were not installed to prevent moisture or water from entering and accumulating within the enclosures: On or before 07/03/2013, the employer did not ensure that electrical equipment, located in the basement of the annealing department, was installed to prevent moisture or water from penetrating the enclosures. Equipment includes the following: a. Two (2), 480 volt disconnect boxes.
Recent events (3)
- — F (S) $1530
- — C (S) $0
- — Z (S) $0
1910.305 B01 I
- Issued
- Dec 16, 2013
- Penalty
- Initial $2,550 · Current $0 Reduced
General-duty citation text
29 CFR 1910.305(b)(1)(i): Conductors entering cutout boxes, cabinets, or fittings were not protected from abrasion, and openings through which conductors enter were not effectively closed. On and before 07/03/2013, unused openings in the electrical distribution cabinets, located in the annealing was not effectively closed.
Recent events (3)
- — F (S) $0
- — C (S) $2550
- — Z (S) $2550
1910.305 B02 I
- Issued
- Dec 16, 2013
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1910.305(b)(2)(i): Pull boxes, junction boxes, and fittings were not provided with covers approved for the purpose: a. The panel covering for the 220 volt electrical distribution cabinet did not fit, and did not effectively enclose the electrical wiring that enter into the junction box. b. A 220 volt electrical receptacle with a missing cover. c. An electrical distribution panel box that was not effectively closed.
Recent events (3)
- — F (S) $0
- — C (S) $0
- — Z (S) $0
More inspections at Arcelormittal USA
View Arcelormittal USA's full OSHA safety record →
More inspections in this industry (NAICS 331111)
More inspections in OH
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 339164089.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.