Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,197,124Inspections Most recent open 2026-08-25 Last loaded 2026-08-28

OSHA Inspection: NAPOLEON MARTINEZ

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of NAPOLEON MARTINEZ in 16111 ROBIN, OMAHA, NE 68114 (NAICS 238160). OSHA activity number 339209835.

What this inspection record means

OSHA opens inspections for many reasons: routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch Napoleon Martinez for free Get an email when a new federal OSHA severe-injury report for Napoleon Martinez is published. One employer, no account, unsubscribe in one click.
Establishment
NAPOLEON MARTINEZ
Site address
16111 ROBIN
City
OMAHA
State
NE
ZIP
68114
Mailing
1414 ST PAUL ROAD #4, GRAND ISLAND, NE 68801
Inspection type
Planned (H)
Scope
Complete (A)
Discipline
Safety
Advance notice
No
Union status
Non-union (B)
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
238160
Employees
5
Ownership type
Private (A)

4 citations on file for this inspection.

1926.307 D01

Serious Gravity 5 1 instance 1 exposed
Issued
Nov 12, 2013
Abate by
Nov 25, 2013
Penalty
Initial $1,440 · Current $1,008 Reduced
29 CFR 1926.307(d)(1): "Guarding." Pulleys, any parts of which are 7 feet (2.128 m) or less from the floor or working platform, were not guarded in accordance with the standards specified in paragraphs (m) and (o) of this section. Pulleys serving as balance wheels (e.g., punch presses) on which the point of contact between belt and pulley is more than 6 ft. 6 in. (1.976 m) from the floor or platform may be guarded with a disk covering the spokes.        Job site located at 16111 Robin, Omaha, NE 68114-Employees were allowed to use an air compressor to operate their nail guns where the belt and pulley on the compressor was not guarded.
Recent events (2)
  • · I (S) $1008
  • · Z (S) $1440

1926.307 E01 I

Serious Gravity 5 1 instance 1 exposed
Issued
Nov 12, 2013
Abate by
Nov 25, 2013
Penalty
Initial $0 · Current $0
29 CFR 1926.307(e)(1)(i): Where both runs of horizontal belts are 7 feet (2.128 m) or less from the floor level, the guard shall extend to at least 15 inches (38.1 cm) above the belt or to a standard height, except that where both runs of a horizontal belt are 42 inches (106.68 cm) or less from the floor, the belt shall be fully enclosed.    Job site located at 16111 Robin Street, Omaha, NE 68114-Employees were allowed to use an air compressor to operate their nail guns while working on the roof where the belt and pulley were not guarded properly.
Recent events (2)
  • · I (S) $0
  • · Z (S) $0

1926.501 B13

Serious Gravity 10 1 instance 2 exposed
Issued
Nov 12, 2013
Abate by
Nov 25, 2013
Penalty
Initial $2,520 · Current $2,016 Reduced
29 CFR 1926.501(b)(13): 29 CFR 1926.501(b)(13):  Employee(s) engaged in residential construction 6  feet (1.8 m) or more above lower levels were not protected from falling by the  use of guardrail systems, safety net systems or personal fall arrest systems  nor was an alternative fall protection plan which meets the requirements of  1926.502(k) developed and implemented :    Job site located at 16111 Robin, Omaha, NE 68114-Employees engaged in residential construction activities 6 feet or more above a lower level were not protected from falling with the use of a guardrail system, safety net system, or personal fall arrest system.
Recent events (2)
  • · I (S) $2016
  • · Z (S) $2520

1926.503 A01

Serious Gravity 5 1 instance 2 exposed
Issued
Nov 12, 2013
Abate by
Nov 25, 2013
Penalty
Initial $1,800 · Current $1,260 Reduced
29 CFR 1926.503(a)(1): The employer did not provide a training program for each employee who might be exposed to fall hazards. The program shall enable each employee to recognize the hazards of falling and shall train each employee in the procedures to be followed in order to minimize these hazards.    Job site located at 16111 Robing Street, Omaha, NE 68114-Employees were allowed to work on a roof exposed to a fall hazard of up to 15 feet above the ground level without having had any fall protection training from the employer.
Recent events (2)
  • · I (S) $1260
  • · Z (S) $1800

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). OSHA publishes its own view of this case as inspection number 339209835.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.