Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,196,249Inspections Most recent open 2026-08-20 Last loaded 2026-08-24

OSHA Inspection: BACHAR CONSTRUCTION CORP.

Programmed Related inspection · Safety discipline

On , OSHA opened a programmed Related safety inspection of BACHAR CONSTRUCTION CORP. in 755 E. 217TH STREET, BRONX, NY 10467 (NAICS 238140). OSHA activity number 339217820.

What this inspection record means

OSHA opens inspections for many reasons: routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch Bachar Construction Corp. for free Get an email when a new federal OSHA severe-injury report for Bachar Construction Corp. is published. One employer, no account, unsubscribe in one click.
Site address
755 E. 217TH STREET
City
BRONX
State
NY
ZIP
10467
Mailing
308 KASKIASKO STREET, BROOKLYN, NY 11221
Inspection type
Programmed Related (I)
Scope
Complete (A)
Discipline
Safety
Advance notice
No
Union status
Non-union (B)
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
238140
Employees
4
Ownership type
Private (A)

5 citations on file for this inspection.

1926.21 B02

Serious Gravity 1 4 instances 4 exposed
Issued
Aug 8, 2013
Penalty
Initial $1,200 · Current $1,200
29 CFR 1926.21(b)(2): The employer shall instruct each employee in the recognition and avoidance of unsafe conditions and the regulations applicable to his work environment to control or eliminate any hazards or other exposure to illness or injury:  On or about 7/18/2013, 755 E. 217th Street  a) The employees were not provided training as required by the standard.
Recent events (1)
  • · Z (S) $1200

1926.100 A

Serious Gravity 5 1 instance 1 exposed
Issued
Aug 8, 2013
Penalty
Initial $1,600 · Current $1,600
29 CFR 1926.100(a): Employees working in areas where there is a possible danger of head injury from impact, or from falling or flying objects, or from electrical shock and burns, shall be protected by protective helmets:  On or about7/18/2013, 755 E. 217th Street  a) The laborers working below the tubular welded frame scaffold were not wearing their hard hats.
Recent events (1)
  • · Z (S) $1600

1926.451 G01

Serious Gravity 10 1 instance 3 exposed
Issued
Aug 8, 2013
Penalty
Initial $2,800 · Current $2,800
29 CFR 1926.451(g)(1): Each employee on a scaffold more than 10 feet (3.1 m) above a lower level shall be protected from falling to that lower level. Paragraphs (g)(1)(i) through (vii) of this section establish the types of fall protection to be provided to the employees on each type of scaffold. Paragraph (g)(2) of this section addresses fall protection for scaffold erectors and dismantlers:  Note to paragraph (g)(1): The fall protection requirements for employees installing suspension scaffold support systems on floors, roofs, and other elevated surfaces are set forth in subpart M of this part.  On or about 7/18/2013, 755 E. 217th Street  a) Employees worked on a tubular welded frame scaffold platform, approximately 20ft above the ground.  The scaffold did not have standard guardrails.
Recent events (1)
  • · Z (S) $2800

1926.501 B04 I

Serious Gravity 10 2 instances 4 exposed
Issued
Aug 8, 2013
Penalty
Initial $2,800 · Current $2,800
29 CFR 1926.501(b)(4)(i): Each employee on walking/working surfaces shall be protected from falling through holes (including skylights) more than 6 feet (1.8 m) above lower levels, by personal fall arrest systems, covers, or guardrail systems erected around such holes:  On or about 7/18/2013, 1st Floor and 2nd Floors  a) There were two unguarded floor openings exposing the employees to a 9' to 18' fall hazard.
Recent events (1)
  • · Z (S) $2800

1926.1053 B01

Serious Gravity 5 1 instance 4 exposed
Issued
Aug 8, 2013
Penalty
Initial $2,000 · Current $2,000
29 CFR 1926.1053(b)(1): When portable ladders are used for access to an upper landing surface, the ladder side rails shall extend at least 3 feet (.9 m) above the upper landing surface to which the ladder is used to gain access; or, when such an extension is not possible because of the ladder's length, then the ladder shall be secured at its top to a rigid support that will not deflect, and a grasping device, such as a grabrail, shall be provided to assist employees in mounting and dismounting the ladder. In no case shall the extension be such that ladder deflection under a load would, by itself, cause the ladder to slip off its support:   On or about 7/18/2013, 1st Floor  a) The employees used a 10' extension ladder that was not secured and did not extend3 ft above the landing. They were exposed to a fall hazard.
Recent events (1)
  • · Z (S) $2000

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). OSHA publishes its own view of this case as inspection number 339217820.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.