Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,992Inspections Most recent open 2026-07-18 Last loaded 2026-07-22

OSHA Inspection: PJ TRAILERS MFG. CO., INC.

Follow-up inspection · Safety discipline

On , OSHA opened a follow-up safety inspection of PJ TRAILERS MFG. CO., INC. in 1807 FM 2352, SUMNER, TX 75486 (NAICS 336212). OSHA activity number 339253452.

What this inspection record means

OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch PJ Trailers MFG. CO., INC. — free Get an email when a new federal OSHA severe-injury report for PJ Trailers MFG. CO., INC. is published. One employer, no account, unsubscribe in one click.
Site address
1807 FM 2352
City
SUMNER
State
TX
ZIP
75486
Mailing
1807 FM 2352, SUMNER, TX 75486
Inspection type
Follow-up (F)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
336212
Employees
300
Ownership type
A

6 citations on file for this inspection.

5(a)(1)

Serious Gravity 10 1 instance 2 exposed
Issued
Jan 30, 2014
Abate by
Feb 6, 2014
Penalty
Initial $7,000 · Current $5,000 Reduced
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish to each of his employees employment and a place of employment which was free from recognized hazards of being struck-by and/or crushed-by suspended loads which were causing or likely to cause death or serious physical harm to employees:     The employer does not remove from service damaged hooks. This violation occurred on August 2, 2013, and at times prior thereto, when employees operating STAHL overhead underhung crane with a broken safety latch at the throat of the hook were exposed to struck-by and/or crushed-by hazards.
Recent events (3)
  • — F (S) $5000
  • — C (S) $7000
  • — Z (S) $7000

1910.178 P01

Other-than-serious 1 instance 1 exposed
Issued
Jan 30, 2014
Abate by
Feb 6, 2014
Penalty
Initial $5,500 · Current $0 Reduced
29 CFR 1910.178(p)(1): Powered industrial truck(s) found to be in need of repair, defective, or in any way unsafe had not been  taken out of service until restored to safe operating condition:    The employer does not ensure forklift trucks found to be in need of repair, defective, or in any way unsafe be taken out of service until restored to safe operating condition.  This violation occurred on July 31, 2013, and at times prior thereto, when an employee operated a Caterpillar forklift #35, model 2PD600, with a missing/broken mirror.
Recent events (3)
  • — F (O) $0
  • — C (S) $5500
  • — Z (S) $5500

1910.334 A02 II

Other-than-serious 2 instances 2 exposed
Issued
Jan 30, 2014
Penalty
Initial $5,500 · Current $0 Reduced
29 CFR 1910.334(a)(2)(ii): There was a defect or evidence of damage that could have exposes an employee to injury and the defective or damaged item was not removed from service:    The employer does not remove from service damaged extension cords. This violation was most recently observed on or about July 31, 2013:    a)  In the Gooseneck department, station #9, where an electrical extension cord used to power a portable angle grinder had damaged insulation.     b)  In the Gooseneck department, station #11, where an electrical extension cord used to power a portable angle grinder had damaged insulation.
Recent events (3)
  • — F (O) $0
  • — C (S) $5500
  • — Z (S) $5500

1910.212 A03 II

Deleted Repeat Gravity 10 1 instance 4 exposed
Issued
Jan 30, 2014
Abate by
Feb 6, 2014
Penalty
Initial $70,000 · Current $0 Reduced
29 CFR 1910.212(a)(3)(ii): Point(s) of operation of machinery were not guarded to prevent employee(s) from having any part of their body in the danger zone(s) during operating cycle(s):  The employer does not protect the point of operation to power press brakes to prevent operators from having any part of their body in the danger zone during the operating cycle.  This violation occurred in the parts fabrication department on or about July 31, 2013, and at times prior thereto; when employees, who operated the Cincinnati, 400AF, power press brake, were not protected from placing their fingers, hands or other body parts into the point of operation during the operating cycle.   The PJ Trailers Mfg. Co., Inc. was previously cited for a violation of this occupational safety and health standard or its equivalent standard 212(a)(3)(ii), which was contained in OSHA inspection number 314181876, citation number 2, item number 4 and was affirmed as a final order on January 9, 2013 with respect to a workplace located at 1807 FM 2352, Summer, TX 75486; And which was contained in OSHA inspection number 312125578, citation number 1, item number , issued on March 2, 2010, with respect to the employer's Delco Trailers workplace located at 4131 CR 35500, Sumner, TX 75486, and was affirmed as a final order on March 24, 2010.
Recent events (3)
  • — F (R) $0
  • — C (R) $70000
  • — Z (R) $70000

1910.305 B01 II

Repeat Gravity 1 1 instance 1 exposed
Issued
Jan 30, 2014
Penalty
Initial $16,500 · Current $14,750 Reduced
29 CFR 1910.305(b)(1)(ii): Unused openings in boxes, cabinets, or fittings were not effectively closed:    The employer does not close unused openings on electrical equipment.  This violation was most recently observed on or about August 1, 2013, at storage/finishing department, where electrical panel #1 was missing circuit breakers #22, #28, #30.     The PJ Trailers Mfg. Co., Inc.; Delco Trailers was previously cited for a violation of this occupational safety and health standard or its equivalent standard 1910.305(b)(1)(ii) which was contained in OSHA inspection number 314181876, citation number 1, item number 16 and was affirmed as a final order on October 18, 2011, with respect to a workplace located at 1807 FM 2352, Summer, TX 75486.
Recent events (3)
  • — F (R) $14750
  • — C (R) $16500
  • — Z (R) $16500

1910.305 G02 III

Deleted Repeat Gravity 1 2 instances 3 exposed
Issued
Jan 30, 2014
Abate by
Feb 6, 2014
Penalty
Initial $16,500 · Current $0 Reduced
29 CFR 1910.305(g)(2)(iii): Flexible cords were not connected to devices and fittings so that tension would not be transmitted to joints or terminal screws:   The employer does not ensure flexible cords are connected to devices and fittings so that tension is not transmitted to joints or terminal screws. This violation was observed on or about:  a)      July 31, 2013, in the finishing department, line 2 where the flexible cord of pedant control station for Stahl crane did not have strain relief device causing a transmission of tension to joints and or terminals.    b)      November 20, 2013, in the warehouse/finishing department, where the flexible cord plugged to electrical panel #1 did not have strain relief device causing a transmission of tension to joints and or terminals.   The P J Trailers Mfg. Co.; Delco Trailers was previously cited for a violation of this occupational safety and health standard or its equivalent standard 1910.305(g)(2)(iii), which was contained in OSHA inspection number 314181876, citation number 3, item number 8b and was affirmed as a final order on January 9, 2013, with respect to a workplace located at 1807 FM 2352, Summer, TX 75486.
Recent events (3)
  • — F (R) $0
  • — C (R) $16500
  • — Z (R) $16500

View PJ Trailers MFG. CO., INC.'s full OSHA safety record →

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 339253452.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.