Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,194,531Inspections Most recent open 2026-08-11 Last loaded 2026-08-14

OSHA Inspection: ENTERPRISE PRODUCTS PARTNERS L.P.

Complaint inspection · Safety discipline

On , OSHA opened a complaint safety inspection of ENTERPRISE PRODUCTS PARTNERS L.P. in CENTRAL TREATING FACILITY 1250 COUNTY ROAD 69, RIFLE, CO 81650 (NAICS 211112). OSHA activity number 339254849.

What this inspection record means

OSHA opens inspections for many reasons: routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch Enterprise Products Partners L.P. for free Get an email when a new federal OSHA severe-injury report for Enterprise Products Partners L.P. is published. One employer, no account, unsubscribe in one click.
Site address
CENTRAL TREATING FACILITY 1250 COUNTY ROAD 69
City
RIFLE
State
CO
ZIP
81650
Mailing
27991 COUNTY ROAD 5, RIFLE, CO 81650
Inspection type
Complaint (B)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
Non-union (B)
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
211112
Employees
4
Ownership type
Private (A)

6 citations on file for this inspection.

1910.23 C02

Serious Gravity 1 1 instance 4 exposed
Issued
Jan 28, 2014
Abate by
Feb 15, 2014
Penalty
Initial $2,550 · Current $6,800
29 CFR 1910.23(e)(1): Standard railing(s) did not consist of top rail, intermediate rail and/or posts and/or did not have a vertical height of 42 inches (106.7 cm) nominal from upper surface of top rail to floor, platform runway, or ramp level:       a)  Enterprise Products Operating, LP at 1250 County Road 69, Rifle, CO 81650: On and before 8/1/13, the employer did not ensure that guardrails were in place. Guardrail around the compressor was missing. The fall height into the pit was measured at approximately 4 feet 11 inches. This condition exposed employees to a fall hazard.       Abatement Note:  Abatement certification is required for this item (see enclosed "Certification of Corrective Action Worksheet").
Recent events (2)
  • · I (S) $6800
  • · Z (S) $2550

1910.119 C01

Deleted Serious Gravity 5 1 instance 4 exposed
Issued
Jan 28, 2014
Abate by
Feb 15, 2014
Penalty
Initial $4,250 · Current $0 Reduced
29 CFR 1910.119(c)(1): The employer did not develop a written plan of action regarding implementation of the employee participation required by 29 CFR 1910.119:     a)    Enterprise Products Operating, LP at 1250 County Road 69, Rifle, CO 81650: On and before 8/1/13, the employer did not develop a written plan of action regarding implementation of the employee participation in the development of a process safety management plan or process hazard analysis. Front line employees were not involved in the development of the process safety management (PSM) program. This condition exposed employees to natural gas, hydrocarbons, benzene, amine, and other chemical hazards associated with operating a natural gas plant.     Abatement Note:  Abatement certification is required for this item (see enclosed "Certification of Corrective Action Worksheet").
Recent events (2)
  • · I (S) $0
  • · Z (S) $4250

1910.119 C02

Deleted Serious Gravity 5 1 instance 4 exposed
Issued
Jan 28, 2014
Abate by
Feb 15, 2014
Penalty
Initial $0 · Current $0
29 CFR 1910.119(c)(2):    The employer did not consult with employees and their representative on the conduct and development of process hazard analyses:     a)    Enterprise Products Operating, LP at 1250 County Road 69, Rifle, CO 81650: On and before 8/1/13, the employer did not include employee involvement by non lead employees in the development of the process hazard analysis (PHA), standard operating procedures, mechanical integrity and incident investigations.     Abatement Note:  Abatement certification is required for this item (see enclosed "Certification of Corrective Action Worksheet").
Recent events (2)
  • · I (S) $0
  • · Z (S) $0

1910.119 E05

Deleted Serious Gravity 5 1 instance 4 exposed
Issued
Jan 28, 2014
Abate by
Feb 15, 2014
Penalty
Initial $4,250 · Current $0 Reduced
29 CFR 1910.119(e)(5): The employer did not establish a system to promptly address the teams findings and recommendations:     a)              Enterprise Products Operating, LP at 1250 County Road 69, Rifle, CO 81650: On and before 8/1/13, the employer did not establish a system to promptly address the teams findings and recommendations in the process hazard analysis (PHA) in a timely manner or that the resolution was documented. Findings include but are not limited to:     1)    The employer failed to modify or relocate the Control room building to lower the maximum predicted BLD below 2 or relocate personnel.  2)    The employer failed to update the facility procedures and ensure all personnel are trained and proficient in PSM standards  3)    The employer did not document inspections of the CTF respiratory protection equipment. The action item was due 4/30/12  Abatement Note:  Abatement certification is required for this item (see enclosed "Certification of Corrective Action Worksheet").
Recent events (2)
  • · I (S) $0
  • · Z (S) $4250

1910.119 I02 IV

Serious Gravity 1 1 instance 4 exposed
Issued
Jan 28, 2014
Abate by
Mar 3, 2014
Penalty
Initial $2,550 · Current $6,800
29 CFR 1910.119(i)(1): The employer did not perform a pre-startup safety review for new facilities and for modified facilities when modification is significant enough to require a change in the process safety information:       a)       Enterprise Products Operating, LP at 1250 County Road 69, Rifle, CO 81650: On and before 8/1/13, the employer did not perform a pre-startup safety review for modified facilities when modification is significant enough to require a change in the process safety information. The employer replaced the Amine sump with a 1000 gallon vessel, replace flash gas line and reroute valve without a PPSR. This condition exposed employees to chemical, fire and explosion hazards.            Abatement Note:  Abatement certification is required for this item (see enclosed "Certification of Corrective Action Worksheet").
Recent events (2)
  • · I (S) $6800
  • · Z (S) $2550

1910.26 C03 I

Other-than-serious 1 instance 4 exposed
Issued
Jan 28, 2014
Abate by
Feb 15, 2014
Penalty
Initial $0 · Current $0
29 CFR 1910.26(c)(3)(i): A simple rule for setting up a ladder at the proper angle is to place the base a distance from the vertical wall equal to one-fourth the working length of the ladder:    (a)            Enterprise Products Operating, LP at 1250 County Road 69, Rifle, CO 81650: On and before 8/1/13, the employer did not ensure that the portable metal ladder in cooling fan and slug catcher was at the proper angle for ensure safe use. The extension ladder was not placed at the proper angle with a secure footing. It was braced against the underside of the cooling fan. Employees use the ladder to perform maintenance work on the fans and the slug catcher. This condition exposed employees to slip, trip, and fall hazards.     Abatement Note:  Abatement certification is required for this item (see enclosed "Certification of Corrective Action Worksheet").
Recent events (2)
  • · I (O) $0
  • · Z (O) $0

View Enterprise Products Partners L.P.'s full OSHA safety record →

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). OSHA publishes its own view of this case as inspection number 339254849.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.