Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,195,903Inspections Most recent open 2026-08-18 Last loaded 2026-08-21

OSHA Inspection: THE SIEBENTHALER COMPANY

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of THE SIEBENTHALER COMPANY in 6000 FAR HILLS AVENUE, CENTERVILLE, OH 45459 (NAICS 561730). OSHA activity number 339353948.

What this inspection record means

OSHA opens inspections for many reasons: routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch The Siebenthaler Company for free Get an email when a new federal OSHA severe-injury report for The Siebenthaler Company is published. One employer, no account, unsubscribe in one click.
Site address
6000 FAR HILLS AVENUE
City
CENTERVILLE
State
OH
ZIP
45459
Mailing
6000 FAR HILLS AVENUE, CENTERVILLE, OH 45459
Inspection type
Planned (H)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
Non-union (B)
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
561730
Employees
20
Ownership type
Private (A)

4 citations on file for this inspection.

1926.501 B01

Serious Gravity 5 1 instance 5 exposed
Issued
Sep 10, 2013
Abate by
Sep 27, 2013
Penalty
Initial $4,500 · Current $2,500 Reduced
29 CFR 1926.501(b)(1): "Unprotected sides and edges." Each employee on a walking/working surface (horizontal and vertical surface) with an unprotected side or edge which is 6 feet (1.8 m) or more above a lower level shall be protected from falling by the use of guardrail systems, safety net systems, or personal fall arrest systems.    On or about August 26, 2013, at 6000 Far Hills Avenue, Centerville, five employees were exposed to a 12 ft. fall hazard while walking on an approximately eight foot wide runway starting from the ladder access point to the flat roof section area where the employees were going to work, approximately 75 feet away.
Recent events (2)
  • · I (S) $2500
  • · Z (S) $4500

1926.501 B10

Serious Gravity 5 1 instance 5 exposed
Issued
Sep 10, 2013
Abate by
Sep 27, 2013
Penalty
Initial $4,500 · Current $0 Reduced
29 CFR 1926.501(b)(10): "Roofing work on Low-slope roofs." Except as otherwise provided in paragraph (b) of this section, each employee engaged in roofing activities on low-slope roofs, with unprotected sides and edges 6 feet (1.8 m) or more above lower levels shall be protected from falling by guardrail systems, safety net systems, personal fall arrest systems, or a combination of warning line system and guardrail system, warning line system and safety net system, or warning line system and personal fall arrest system, or warning line system and safety monitoring system. Or, on roofs 50-feet (15.25 m) or less in width (see Appendix A to subpart M of this part), the use of a safety monitoring system alone [i.e. without the warning line system] is permitted.    On or about August 26, 2013 at 6000 Far Hills Avenue, Centerville, five employees were exposed to a 12 ft. fall hazard while removing ballasted roof gravel from a flat roof section without utilizing any fall protection.
Recent events (2)
  • · I (S) $0
  • · Z (S) $4500

1926.503 A01

Serious Gravity 5 1 instance 5 exposed
Issued
Sep 10, 2013
Abate by
Sep 27, 2013
Penalty
Initial $4,500 · Current $2,000 Reduced
29 CFR 1926.503(a)(1): The employer shall provide a training program for each employee who might be exposed to fall hazards. The program shall enable each employee to recognize the hazards of falling and shall train each employee in the procedures to be followed in order to minimize these hazards.    The Company did not provide training to four employees working on a low slope roof to recognize the hazards of falling and the procedures to minimize these hazards.
Recent events (2)
  • · I (S) $2000
  • · Z (S) $4500

1926.1053 B01

Serious Gravity 5 1 instance 5 exposed
Issued
Sep 10, 2013
Abate by
Sep 20, 2013
Penalty
Initial $4,500 · Current $2,000 Reduced
29 CFR 1926.1053(b)(1): When portable ladders are used for access to an upper landing surface, the ladder side rails shall extend at least 3 feet (.9 m) above the upper landing surface to which the ladder is used to gain access; or, when such an extension is not possible because of the ladder's length, then the ladder shall be secured at its top to a rigid support that will not deflect, and a grasping device, such as a grabrail, shall be provided to assist employees in mounting and dismounting the ladder. In no case shall the extension be such that ladder deflection under a load would, by itself, cause the ladder to slip off its support.     On or about August 26, 2013, at 6000 Far Hills Avenue, Centerville, five employees were exposed to a fall hazard while ascending and descending from a metal extension ladder that extended only 18 inches above the overhang leading to the flat roof area of the building.
Recent events (2)
  • · I (S) $2000
  • · Z (S) $4500

View The Siebenthaler Company's full OSHA safety record →

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). OSHA publishes its own view of this case as inspection number 339353948.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.