OSHA Inspection: OSC EQUIPMENT SERVICES, INC.

Issued

2013-09-18 00:00:00

Abate by

2013-10-19 00:00:00

Penalty

Initial $2975.00 · Current $0.00 Reduced

General-duty citation text

29 CFR 1910.147(c)(4)(ii)(C): The energy control procedure did not clearly and specifically outline the steps for placement, removal and transfer of lockout devices or tagout devices and the responsibility for them.    a) On or about 09/12/2013 in the shop, where the energy control program did not outline and document specific steps for removal of lockout devices by other than the employee who applied the device.    ABATEMENT CERTIFICATION REQUIRED

Issued

2013-09-18 00:00:00

Abate by

2013-10-19 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1910.147(c)(6)(i): The employer did not conduct a periodic inspection of the energy control procedure at least annually to ensure that the procedure and the requirement of this standard were being followed:  a) On or about 09/12/2013 in the shop, where employees perform servicing and maintenance such as, but not limited to: changing band saw blades, press brake dies and the shear blade on the Cincinnati shear.  ABATEMENT CERTIFICATION REQUIRED

Issued

2013-09-18 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1910.305(g)(1)(iv)(A): Flexible cords and/or cables were used as a substitute for the fixed wiring of a structure:  a) On ior about 09/12/2013 in the engine rebuild area; where an extension cord was run in place of fixed wiring to supply power to a parts washer.  NO ABATEMENT CERTIFICATION REQUIRED