GRIFFIN, GA ·
OSHA Inspection: K & K MANUFACTURING, INC.
Complaint inspection · Safety discipline
At a glance
On , OSHA opened a complaint safety inspection of K & K MANUFACTURING, INC. in 1304 19/41 BYPASS SOUTH, GRIFFIN, GA 30224 (NAICS 336120). OSHA activity number 339426835.
OSHA opens inspections for many reasons: routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- K & K MANUFACTURING, INC.
- Site address
- 1304 19/41 BYPASS SOUTH
- City
- GRIFFIN
- State
- GA
- ZIP
- 30224
- Mailing
- 1304 19/41 BYPASS SOUTH, GRIFFIN, GA 30224
What kind of inspection was it?
- Inspection type
- Complaint (B)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- Non-union (B)
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 336120
- Employees
- 12
- Ownership type
- Private (A)
Citations
4 citations on file for this inspection.
5(a)(1)
- Issued
- Dec 16, 2013
- Abate by
- Dec 27, 2013
- Penalty
- Initial $2,000 · Current $1,000 Reduced
General-duty citation text
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to the hazard(s) of crushing and struck-by. a) Throughout fabrication areas - The employer did not ensure that shop made below the hook lifting devices were rated, tested or approved for their use, which exposed employees to crushing and struck-by hazards.
Recent events (2)
- · I (S) $1000
- · Z (S) $2000
1910.178 P01
- Issued
- Dec 16, 2013
- Abate by
- Dec 27, 2013
- Penalty
- Initial $2,000 · Current $0 Reduced
General-duty citation text
29 CFR 1910.178(p)(1): Powered industrial truck(s) found to be in need of repair, defective, or in any way unsafe had not been taken out of service until restored to safe operating condition: a. Hyster Forklift - The forklift was in need of repair and had not been taken out of service when it did not have functional rear lights or backup alarm.
Recent events (2)
- · I (S) $0
- · Z (S) $2000
1910.184 C01
- Issued
- Dec 16, 2013
- Abate by
- Dec 27, 2013
- Penalty
- Initial $2,000 · Current $1,000 Reduced
General-duty citation text
29 CFR 1910.184(c)(1): Sling(s) that were damaged or defective were used: a. Fabrication area - Two worn and damaged slings were not removed from service thereby exposing employees to crushing hazards.
Recent events (2)
- · I (S) $1000
- · Z (S) $2000
1910.305 G02 III
- Issued
- Dec 16, 2013
- Abate by
- Dec 27, 2013
- Penalty
- Initial $2,000 · Current $1,000 Reduced
General-duty citation text
29 CFR 1910.305(g)(2)(iii): Flexible cords and cables were not connected to devices and fittings so that strain relief was provided that would prevent pull from being directly transmitted to joints or terminal screws: a. Bay 14 - The electrical cord which powered the overhead hoist was not provided with strain relief thereby exposing employees to shock hazards.
Recent events (2)
- · I (S) $1000
- · Z (S) $2000
More inspections in this industry (NAICS 336120)
More inspections in GA
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). OSHA publishes its own view of this case as inspection number 339426835.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.