Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,194,531Inspections Most recent open 2026-08-11 Last loaded 2026-08-14

OSHA Inspection: CLINTON HENRY

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of CLINTON HENRY in 4501 W. 127TH ST., ALSIP, IL 60803 (NAICS 238130). OSHA activity number 339507204.

What this inspection record means

OSHA opens inspections for many reasons: routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch Clinton Henry for free Get an email when a new federal OSHA severe-injury report for Clinton Henry is published. One employer, no account, unsubscribe in one click.
Establishment
CLINTON HENRY
Site address
4501 W. 127TH ST.
City
ALSIP
State
IL
ZIP
60803
Mailing
1916 S. LEAVITT ST., CHICAGO, IL 60608
Inspection type
Planned (H)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
238130
Employees
4
Ownership type
A

5 citations on file for this inspection.

1926.20 B01

Serious Gravity 1 1 instance 2 exposed
Issued
Dec 19, 2013
Abate by
Jan 16, 2014
Penalty
Initial $1,200 · Current $1,200
29 CFR 1926.20(b)(1): It shall be the responsibility of the employer to initiate and maintain such programs as may be necessary to comply with this part.  a.  On or about December 4, 2013 - at the above addressed jobsite, the employer did not initiate and maintain an accident prevention program and/or safety and health program to comply with the regulations of this part which included, but were not limited to employee protection when exposed to fall hazards.
Recent events (1)
  • · Z (S) $1200

1926.454 A

Serious Gravity 1 1 instance 1 exposed
Issued
Dec 19, 2013
Abate by
Jan 16, 2014
Penalty
Initial $0 · Current $0
29 CFR 1926.454(a): The employer shall have each employee who performs work while on a scaffold trained by a person qualified in the subject matter to recognize the hazards associated with the type of scaffold being used and to understand the procedures to control or minimize those hazards. The training shall include the following areas, as applicable:   a.  On or about December 4, 2013 - at the above addressed jobsite, an employee using the JLG Telescopic Boom Aerial Lift truck was not trained to recognize the hazards associated with the use of aerial lifts, thereby exposing the employee to the hazards associated with falls.
Recent events (1)
  • · Z (S) $0

1926.503 A01

Serious Gravity 1 1 instance 2 exposed
Issued
Dec 19, 2013
Abate by
Jan 16, 2014
Penalty
Initial $0 · Current $0
29 CFR 1926.503(a)(1): The employer shall provide a training program for each employee who might be exposed to fall hazards. The program shall enable each employee to recognize the hazards of falling and shall train each employee in the procedures to be followed in order to minimize these hazards.  a. On or about December 4, 2013 - at the above addressed jobsite, the employer failed to provide a training program for each employee who might be exposed to fall hazards.
Recent events (1)
  • · Z (S) $0

1926.453 B02 V

Serious Gravity 5 1 instance 1 exposed
Issued
Dec 19, 2013
Penalty
Initial $2,400 · Current $2,400
29 CFR 1926.453(b)(2)(v): A body belt shall be worn and a lanyard attached to the boom or basket when working from an aerial lift.  a.  On or about December 4, 2013 - at the above addressed jobsite, an employee working in the JLG Telescopic Boom Aerial was not attached to the boom or basket by the use of a body harness and lanyard, thereby exposing the employee to the hazards associated with falls.
Recent events (1)
  • · Z (S) $2400

1926.501 B15

Serious Gravity 10 1 instance 1 exposed
Issued
Dec 19, 2013
Abate by
Dec 26, 2013
Penalty
Initial $2,800 · Current $2,800
29 CFR 1926.501(b)(15): "Walking/working surfaces not otherwise addressed." Except as provided in 1926.500(a)(2) or in 1926.501 (b)(1) through (b)(14), each employee on a walking/working surface 6 feet (1.8 m) or more above lower levels shall be protected from falling by a guardrail system, safety net system, or personal fall arrest system.  a. On or about December 4, 2013 - at the above addressed jobsite, an employee conducting metal framing operations from a structural beam approximately twelve (12) feet above the ground was not protected from falling, thereby exposing the employee to fall hazards.
Recent events (1)
  • · Z (S) $2800

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 339507204.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.