Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,992Inspections Most recent open 2026-07-18 Last loaded 2026-07-22

OSHA Inspection: BUCK ROOFING INC.

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of BUCK ROOFING INC. in 1602 N. MAIN ST., HUTCHINSON, KS 67501 (NAICS 238160). OSHA activity number 339509903.

What this inspection record means

OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch Buck Roofing INC. — free Get an email when a new federal OSHA severe-injury report for Buck Roofing INC. is published. One employer, no account, unsubscribe in one click.
Establishment
BUCK ROOFING INC.
Site address
1602 N. MAIN ST.
City
HUTCHINSON
State
KS
ZIP
67501
Mailing
28 DETROIT DRIVE, HUTCHINSON, KS 67505
Inspection type
Planned (H)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
238160
Employees
4
Ownership type
A

4 citations on file for this inspection.

1926.451 B01

Serious Gravity 5 1 instance 1 exposed
Issued
Feb 18, 2014
Abate by
Apr 21, 2014
Penalty
Initial $2,000 · Current $2,000
29 CFR 1926.451(b)(1):  Platform(s) on all working levels of scaffolds, were not fully planked or decked between the front uprights and guardrail supports such that the space between adjacent units, and the space between the platform and the uprights is no more than 1 inch (2.5 cm) wide, and the employer could not demonstrate that a wider space was necessary:  At the job site, 1602 N. Main, Hutchinson, Kansas, employee was working from the top working level of the framed scaffold south section without full planking.  Employees were exposed to fall hazards of approximatley 18 feet to the concrete surface.
Recent events (1)
  • — Z (S) $2000

1926.451 G01

Serious Gravity 10 2 instances 2 exposed
Issued
Feb 18, 2014
Abate by
Apr 21, 2014
Penalty
Initial $0 · Current $0
29 CFR 1926.451(g)(1): Each employee on a scaffold more than 10 feet (3.1 m) above a lower level shall be protected from falling to that lower level. Paragraphs (g)(1)(i) through (vii) of this section establish the types of fall protection to be provided to the employees on each type of scaffold. Paragraph (g)(2) of this section addresses fall protection for scaffold erectors and dismantlers.  At the job site:  1602 N. Main, Hutchinson Kansas, employees were working from the following scaffold areas without a fall protection system in place.  Employees were exposed to fall hazards of approximately 18 feet.       a.  Employees were working from the Werner Aluminum work platform without a fall protection system in place.      b.  Employees were working from the south steel framed scaffold without the top guardrails in place.
Recent events (1)
  • — Z (S) $0

1926.451 F03

Serious Gravity 5 1 instance 2 exposed
Issued
Feb 18, 2014
Abate by
Apr 21, 2014
Penalty
Initial $2,000 · Current $2,000
29 CFR 1926.451(f)(3): Scaffolds and scaffold components shall be inspected for visible defects by a competent person before each work shift, and after any occurrence which could affect a scaffold's structural integrity.  At the job site, 1602 N, Main, Hutchinson, Kansas, the employer did not inspect the scaffolds for visible defects by a competent person before employees began to work.  Fall protection systems and full planking were not in place.  Employees were exposed to fall hazards of approximately 18 feet.
Recent events (1)
  • — Z (S) $2000

1926.454 A

Other-than-serious 1 instance 2 exposed
Issued
Feb 18, 2014
Abate by
Apr 21, 2014
Penalty
Initial $0 · Current $0
29 CFR 1926.454(a): The employer shall have each employee who performs work while on a scaffold trained by a person qualified in the subject matter to recognize the hazards associated with the type of scaffold being used and to understand the procedures to control or minimize those hazards. The training shall include the following areas, as applicable:   At the job site, 1602 N, Main, Hutchinson, Kansas, the employer had not trained each employee to recognize fall hazards when working from welded framed scaffolds and aluminum planks and to implement fall protection systems to minimize fall hazards.  Employees were exposed to fall hazards of approximately 18 feet.
Recent events (1)
  • — Z (O) $0

View Buck Roofing INC.'s full OSHA safety record →

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 339509903.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.