Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,992Inspections Most recent open 2026-07-18 Last loaded 2026-07-22

OSHA Inspection: VICVIK CONSTRUCTION, INC.

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of VICVIK CONSTRUCTION, INC. in 27477 PARLANGE LANE LOT 3, DAPHNE, AL 36526 (NAICS 238160). OSHA activity number 339574683.

What this inspection record means

OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch Vicvik Construction, INC. — free Get an email when a new federal OSHA severe-injury report for Vicvik Construction, INC. is published. One employer, no account, unsubscribe in one click.
Site address
27477 PARLANGE LANE LOT 3
City
DAPHNE
State
AL
ZIP
36526
Mailing
3495 SCENIC HWY, PENSACOLA, FL 32503
Inspection type
Planned (H)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
238160
Employees
4
Ownership type
A

3 citations on file for this inspection.

1926.502 D15

Other-than-serious 1 instance 2 exposed
Issued
Feb 7, 2014
Abate by
Feb 20, 2014
Penalty
Initial $1,224 · Current $0 Reduced
29 CFR 1926.502(d)(15): Anchorage used for attachment for personal fall arrest equipment was not capable of supporting at least 5,000 pounds (22.2 kN) per employee attached nor was it designed, installed and used as follows: As part of a complete personal fall arrest system which maintains a safety factor of at least two; and under the supervision of a qualified person:    a)  Roof: On or about January 22, 2014, the employer allowed more than one employee to simultaneously tie off their personal fall arrest systems to a single anchor device which was not the design and/or intended use of the anchor device and exposed employees to a fall of 10-feet from the eave to the unfinished ground below.
Recent events (2)
  • — I (O) $0
  • — Z (S) $1224

1926.1053 B01

Serious Gravity 5 3 instances 4 exposed
Issued
Feb 7, 2014
Penalty
Initial $1,040 · Current $624 Reduced
29 CFR 1926.1053(b)(1): When portable ladders are used for access to an upper landing surface, the ladder side rails shall extend at least 3 feet (.9 m) above the upper landing surface to which the ladder is used to gain access; or, when such an extension is not possible because of the ladder's length, then the ladder shall be secured at its top to a rigid support that will not deflect, and a grasping device, such as a grabrail, shall be provided to assist employees in mounting and dismounting the ladder. In no case shall the extension be such that ladder deflection under a load would, by itself, cause the ladder to slip off its support:  a) Metal extension ladder: On or about January 22, 2014, the employer allowed a ladder to be used while  the top of the ladder was set up in the roof soffit rather than extending at least 3-feet above the landing surface which exposed employees to a fall of 10-feet to the unfinished ground below.  b) Metal ladders: On or about January 22, 2014, the employer allowed 2-ladders of insufficient length to be used while the top was not secured and no grasping device was provided which exposed employees to falls up to 10-feet from the top of the ladder/landing surface area to the unfinished ground below.
Recent events (2)
  • — I (S) $624
  • — Z (S) $1040

1926.501 B13

Repeat Gravity 5 1 instance 2 exposed
Issued
Feb 7, 2014
Abate by
Feb 20, 2014
Penalty
Initial $2,880 · Current $1,728 Reduced
29 CFR 1926.501(b)(13): Each employee(s) engaged in residential construction activities 6 feet (1.8 m) or more above lower levels were not protected by guardrail systems, safety net system, or personal fall arrest system, nor were employee(s) provided with an alternative fall protection measure under another provision of paragraph 1926.501 (b):   a)  Roof: On or about January 22, 2014, the employer allowed employees to work on the roof without fall protection which exposed employees to a fall of 10-feet from the eave to the unfinished ground below.  Vicvik Construction, Inc. was previously cited for a violation of this occupational safety and health standard or its equivalent standard 1926.501(b)(13), which was contained in OSHA inspection number 949300, citation number 1, item number 1 and was affirmed as a final order on December 20, 2013, with respect to a workplace located at 7697 Raegan Lane, Spanish Fort, AL 36527.
Recent events (2)
  • — I (R) $1728
  • — Z (R) $2880

View Vicvik Construction, INC.'s full OSHA safety record →

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 339574683.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.