OSHA Inspection: CHARLES CONSTRUCTION

Issued

Feb 26, 2014

Abate by

Mar 4, 2014

Penalty

Initial $2,400 · Current $2,400

General-duty citation text

29 CFR 1926.501(b)(13): Each employee(s) engaged in residential construction activities 6 feet (1.8 m) or more above lower levels were not protected by guardrail systems, safety net system, or personal fall arrest system, nor were employee(s) provided with an alternative fall protection measure under another provision of paragraph 1926.501 (b):  a)  W. Main St. and Murray St., Newark, DE - Employees were conducting framing operations without the use of fall protection while working at a height of 10 feet above ground level.  Observed on or about February 6, 2014.

Issued

Feb 26, 2014

Abate by

Mar 24, 2014

Penalty

Initial $0 · Current $0

General-duty citation text

29 CFR 1926.503(a)(1): The employer did not provide a training program for each employee potentially exposed to fall hazards to enable each employee to recognize the hazards of falling and the procedures to be followed in order to minimize these hazards:  a)  W. Main St. and Murray St.,  Newark, DE - Employees were conducting framing operations at approximately 10 feet above ground level and had not received fall protection training.  Observed on or about 2/06/14.  ­Abatement Note    The training program must enable the employees to recognize the hazards of falling and must train each employee in the procedures to be followed in order to minimize these hazards.  Each employee must be trained by a competent person in the following:    1.  The nature of fall hazards in the work area; 2.  The correct procedures for erecting, maintaining, disassembling, and inspecting the fall protection systems to be used; 3.  The use and operation of guardrail systems, personal fall arrest systems, safety net systems, warning line systems, safety monitoring systems, controlled access zones, and other protection to be used; 4.  The role of each employee in the safety monitoring system when this system is used; 5.  The limitations on the use of mechanical equipment during the performance of roofing work on low-sloped roofs; 6.  The correct procedures for the handling and storage of equipment and materials and the erection of overhead protection; 7.  The role of employees in fall protection plans; 8.  The standards contained in this subpart.    The employer must verify compliance with paragraph (a) of this section by preparing a written certification record that will contain the name or other identity of the employee trained, the date(s) of the training, and the signature of the person who conducted the training or the signature of the employer.