Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,198,892Inspections Most recent open 2026-09-03 Last loaded 2026-09-07

OSHA Inspection: SEARS ROEBUCK & COMPANY

Complaint inspection · Safety discipline

On , OSHA opened a complaint safety inspection of SEARS ROEBUCK & COMPANY in 300 BEAVER VALLEY MALL, MONACA, PA 15061 (NAICS 811198). OSHA activity number 339581027.

What this inspection record means

OSHA opens inspections for many reasons: routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch Sears Roebuck & Company for free Get an email when a new federal OSHA severe-injury report for Sears Roebuck & Company is published. One employer, no account, unsubscribe in one click.
Site address
300 BEAVER VALLEY MALL
City
MONACA
State
PA
ZIP
15061
Mailing
300 BEAVER VALLEY MALL, MONACA, PA 15061
Inspection type
Complaint (B)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
Non-union (B)
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
811198
Employees
14
Ownership type
Private (A)

4 citations on file for this inspection.

5(a)(1)

Serious Gravity 5 1 instance 9 exposed
Issued
Jun 23, 2014
Abate by
Jul 3, 2014
Penalty
Initial $2,000 · Current $1,200 Reduced
OSH ACT of 1970 Section (5)(a)(1): The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to crushed-by hazards while using a defective Rotary brand swing air jack to lift vehicles.  Main Shop Area, Bay #14, 300 Beaver Valley Mall, Monaca, PA 15061:  Observed on or about February 10, 2014, the secondary lift (Rotary brand swing air jack) on a Rotary brand two post lift was exhibiting signs of erratic operation.  The November 2013 monthly inspection report for this automotive lift reads "Secondary jacks seem week and not wanting to lift vehicles."  The lift was not immediately taken out of service and repaired by a qualified person.  Employees using the secondary lift were exposed to crushed-by hazards.
Recent events (2)
  • · I (S) $1200
  • · Z (S) $2000

1910.36 D01

Serious Gravity 5 2 instances 9 exposed
Issued
Jun 23, 2014
Abate by
Jun 27, 2014
Penalty
Initial $2,000 · Current $1,200 Reduced
29 CFR 1910.36(d)(1):  A required exit(s), way of approach thereto, and/or way of travel from the exit into the street or open space, was not continuously maintained free of all obstructions or impediments to full instant use in the case of fire or other emergency:      a) Shop area, 300 Beaver Valley Mall, Monaca, PA 15061:  Observed on or about February 10, 2014, an emergency exit door leading from the shop area to the outside was locked with a padlock.  Employees working in the shop area were exposed to fire and smoke inhalation hazards.
Recent events (2)
  • · I (S) $1200
  • · Z (S) $2000

1910.219 D01

Deleted Other-than-serious 1 instance 9 exposed
Issued
Jun 23, 2014
Abate by
Jul 18, 2014
Penalty
Initial $0 · Current $0
29 CFR 1910.219(d)(1): Pulley(s) with part(s) seven feet or less from the floor or work platform were not guarded in accordance with the requirements specified in 29 CFR 1910.219(m) and (o):   a) Compressor room, 300 Beaver Valley Mall, Monaca, PA 15061:  Observed on or about February 10, 2014, the pulley on the left air compressor located in the compressor room was not fully enclosed.  The side of the pulley facing the workspace was not completely enclosed.  Employees working in the compressor room were exposed to caught-by hazards created by the partially exposed rotating pulley.
Recent events (2)
  • · I (O) $0
  • · Z (O) $0

1910.219 E01 I

Deleted Other-than-serious 1 instance 9 exposed
Issued
Jun 23, 2014
Abate by
Jul 18, 2014
Penalty
Initial $0 · Current $0
29 CFR 1910.219(e)(1)(i):  Horizontal belts which had both runs seven feet or less from the floor level were not guarded with a guard that extended to at least fifteen inches above the belt:     a) Compressor room, 300 Beaver Valley Mall, Monaca, PA 15061:  Observed on or about February 10, 2014, the belt on the left air compressor located in the compressor room was not fully enclosed.  The side of the belt facing the workspace was not completely enclosed.  Employees working in the compressor room were exposed to caught-by hazards created by the partially unguarded rotating belt on the compressor.
Recent events (2)
  • · I (O) $0
  • · Z (O) $0

View Sears Roebuck & Company's full OSHA safety record →

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). OSHA publishes its own view of this case as inspection number 339581027.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.