Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,992Inspections Most recent open 2026-07-18 Last loaded 2026-07-22

OSHA Inspection: SALINAS FRAMING

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of SALINAS FRAMING in 1207 ROWAN DRIVE, GEORGETOWN, TX 78628 (NAICS 238130). OSHA activity number 339596330.

What this inspection record means

OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch Salinas Framing — free Get an email when a new federal OSHA severe-injury report for Salinas Framing is published. One employer, no account, unsubscribe in one click.
Establishment
SALINAS FRAMING
Site address
1207 ROWAN DRIVE
City
GEORGETOWN
State
TX
ZIP
78628
Mailing
6413 BOYCE LANE, AUSTIN, TX 78754
Inspection type
Planned (H)
Scope
Complete (A)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
238130
Employees
4
Ownership type
A

5 citations on file for this inspection.

1926.100 A

Serious Gravity 1 1 instance 2 exposed
Issued
Feb 27, 2014
Abate by
Mar 5, 2014
Penalty
Initial $1,200 · Current $750 Reduced
29 CFR 1926.100(a): Employees working in areas where there was a possible danger of head injury from impact, or falling or flying objects, or from electrical shock and burns, were not protected by protective helmets.     On or about 14 February 2014, and at times prior thereto, a framer was handing pieces of lumber up to another framer at the first floor top plate without the use of head protection for both, exposing the framers to the hazard of being struck by falling materials, tools, or debris.
Recent events (2)
  • — I (S) $750
  • — Z (S) $1200

1926.405 G02 IV

Serious Gravity 5 1 instance 4 exposed
Issued
Feb 27, 2014
Penalty
Initial $2,040 · Current $750 Reduced
29 CFR 1926.405(g)(2)(iv): Strain relief. Flexible cords were not connected to devices and fittings so that strain relief is provided which will prevent pull from being directly transmitted to joints or terminal screws.     On or about 14 February 2014, and at times prior thereto, four framers were using an extension cord that had strain relief damage, while it was plugged into a radio/charger being used on site, exposing the framers to an electrical hazard of approximately 120 volts.
Recent events (2)
  • — I (S) $750
  • — Z (S) $2040

1926.416 E01

Serious Gravity 5 1 instance 4 exposed
Issued
Feb 27, 2014
Penalty
Initial $0 · Current $0
29 CFR 1926.416(e)(1): Worn or frayed electric cords or cables were used.   On or about 14 February 2014, and at times prior thereto, four framers were using an extension cord that had damage to the wire, while it was plugged into a radio/charger being used on site, exposing the framers to an electrical hazard of approximately 120 volts.
Recent events (2)
  • — I (S) $0
  • — Z (S) $0

1926.501 B13

Serious Gravity 5 1 instance 2 exposed
Issued
Feb 27, 2014
Abate by
Mar 5, 2014
Penalty
Initial $2,400 · Current $750 Reduced
29 CFR 1926.501(b)(13): Each employee(s) engaged in residential construction activities 6 feet (1.8 m) or more above lower levels were not protected by guardrail systems, safety net system, or personal fall arrest system, nor were employee(s) provided with an alternative fall protection measure under another provision of paragraph 1926.501 (b).     On or about 14 February 2014, and at times prior thereto, two framers were working at the first floor top plate without the use of fall protection, exposing the framers to a fall hazard of approximately 159 inches or 13 feet 3 inches.
Recent events (2)
  • — I (S) $750
  • — Z (S) $2400

1926.1053 B13

Serious Gravity 5 1 instance 2 exposed
Issued
Feb 27, 2014
Abate by
Mar 5, 2014
Penalty
Initial $2,400 · Current $750 Reduced
29 CFR 1926.1053(b)(13): The top or top step of a stepladder cannot be used as a step.     On or about 14 February 2014, and at times prior thereto, two framers accessed the first floor top plate of a residence under construction using a six foot stepladder, requiring them to use the top step, exposing the two framers to a fall hazard of approximately 13 feet 3 inches.
Recent events (2)
  • — I (S) $750
  • — Z (S) $2400

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 339596330.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.