OSHA Inspection: CAMP MOKULE'IA

Issued

2014-03-20 00:00:00

Penalty

Initial $1360.00 · Current $460.00 Reduced

General-duty citation text

29 CFR 1910.36(g)(2): Exit access(es) were not at least 28 inches (71.1 cm) wide at all points:     On or about 02/28/14, in the office area, the exit access from the cubic office to the exit door narrowed to 16 inches wide.    ABATEMENT VERIFICATION IS NOT REQUIRED PURSUANT TO 29 CFR 1903.19.

Issued

2014-03-20 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1910.37(b)(7): Each exit sign did not have the word "Exit" in plainly legible letters not less than six inches (15.2 cm) high, with the principal strokes of the letters in the word "Exit" not less than three fourths of an inch (1.9 cm) wide:   On or about 02/28/14, an exit door in the front of the office was not equipped with an Exit sign.  ABATEMENT VERIFICATION IS NOT REQUIRED PURSUANT TO 29 CFR 1903.19.

Issued

2014-03-20 00:00:00

Penalty

Initial $1360.00 · Current $450.00 Reduced

General-duty citation text

29 CFR 1910.213(d)(1): Circular handfed crosscut table saw(s) were not guarded by an automatically adjusting hood which completely enclosed that portion of the saw above the table and above the material being:    On or about 02/28/14, at the maintenance shop, the guard on the 10-inch Ridgid table saw model TS2400 was missing.  The employees using the table saw were exposed to an amputation hazard.      ABATEMENT VERIFICATION IS NOT REQUIRED PURSUANT TO 29 CFR 1903.19.

Issued

2014-03-20 00:00:00

Penalty

Initial $1360.00 · Current $450.00 Reduced

General-duty citation text

29 CFR 1910.215(b)(9): The distance between the abrasive wheel periphery(s) and the adjustable tongue or the end of the safety guard peripheral member at the top exceeded one fourth inch:     a)    On or about 02/28/14, at the maintenance shop, the tongue guard at the top of the 6-inch 1/3 HP bench grinder was missing.  The distance between the casing and abrasive wheel periphery was approximately one inch.      ABATEMENT VERIFICATION IS NOT REQUIRED PURSUANT TO 29 CFR 1903.19.