Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,191,288Inspections Most recent open 2026-07-24 Last loaded 2026-07-29

OSHA Inspection: RODOLFO MARTINEZ-VEGA

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of RODOLFO MARTINEZ-VEGA in 1050 RUBEN M. TORRES BLVD, BROWNSVILLE, TX 78520 (NAICS 238140). OSHA activity number 339668477.

What this inspection record means

OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch Rodolfo Martinez-Vega — free Get an email when a new federal OSHA severe-injury report for Rodolfo Martinez-Vega is published. One employer, no account, unsubscribe in one click.
Site address
1050 RUBEN M. TORRES BLVD
City
BROWNSVILLE
State
TX
ZIP
78520
Mailing
1337 CALLE SAN LUCAS, SAN BENITO, TX 78586
Inspection type
Planned (H)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
238140
Employees
7
Ownership type
A

5 citations on file for this inspection.

1926.451 B01

Serious Gravity 10 1 instance 2 exposed
Issued
Apr 17, 2014
Abate by
May 15, 2014
Penalty
Initial $2,800 · Current $2,800
29 CFR 1926.451(b)(1): Each platform on all working levels of scaffolds shall be fully planked or decked between the front uprights and the guardrail supports as follows:  At this job site, employees were working on a tubular frame scaffold where the platform was not fully planked.  The employees were exposed to a fall hazard up to 17 feet to the ground below.
Recent events (1)
  • — Z (S) $2800

1926.451 C02

Serious Gravity 10 1 instance 2 exposed
Issued
Apr 17, 2014
Abate by
May 15, 2014
Penalty
Initial $0 · Current $0
29 CFR 1926.451(c)(2): Supported scaffold poles, legs, posts, frames, and uprights did not bear on base plates and mud sills or other adequate firm foundation:  At this job site, a tubular frame scaffold was erected without base plates affecting the scaffold's structural integrity and exposing the employees to fall hazards.
Recent events (1)
  • — Z (S) $0

1926.451 E01

Serious Gravity 10 1 instance 2 exposed
Issued
Apr 17, 2014
Abate by
May 15, 2014
Penalty
Initial $0 · Current $0
29 CFR 1926.451(e)(1): When scaffold platforms were more than 2 feet (0.6 m) above or below a point of access, portable ladders, hook-on ladders, attachable ladders, stair towers (scaffold stairways/towers), stairway-type ladders (such as ladder stands), ramps, walkways, integral prefabricated scaffold access, or direct access from other scaffold, sturcure, personnel hoist, or similar surface was not used.  Crossbraces were used as a means of access:  At a commercial building under renovation, employees were using a tubular frame scaffold with no access provided by the employer.  Employees were exposed to fall hazards of 17 feet or more to the ground below.
Recent events (1)
  • — Z (S) $0

1926.451 G01 VII

Serious Gravity 10 1 instance 2 exposed
Issued
Apr 17, 2014
Abate by
May 15, 2014
Penalty
Initial $0 · Current $0
29 CFR 1926.451(g)(1)(vii): Each employee on a scaffold, not otherwise specified in paragraphs (g)(1)(i) through (g)(1)(vi) of this section, more than 10 feet (3.1 m) above lower level was not protected from falls by the use of personal fall arrest systems or guardrail systems meeting the requirements of paragraph (g)(4) of this section:  At this commercial building project, employees were applying stucco to the north side of the building under renovation and did not have fall protection to prevent a fall to ground level.  At this job site personal fall arrest equipment was not in use; neither guardrails nor nets were installed.
Recent events (1)
  • — Z (S) $0

1926.451 H02 II

Serious Gravity 5 1 instance 2 exposed
Issued
Apr 17, 2014
Abate by
May 15, 2014
Penalty
Initial $0 · Current $0
29 CFR 1926.451(h)(2)(ii): A toeboard was not erected along the edge of platforms more than 10 feet (3.1 m) above lower levels for a distance sufficient to protect employees below:Note:  This requirement does not apply to float (ship) scaffolds where an edging of 3/4 inch x 1 1/2 inch (2 x 4 cm) wood or equivalent was used in lieu of toeboards:  At this commercial building under renovation, the employer failed to provide falling object protection to employees, by not ensuring toe boards were installed on the edges of scaffolds,  to prevent struck-by hazards to employees working below the scaffolds.
Recent events (1)
  • — Z (S) $0

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 339668477.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.