Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,992Inspections Most recent open 2026-07-18 Last loaded 2026-07-22

OSHA Inspection: THE DAIMLER GROUP

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of THE DAIMLER GROUP in 3750 AGLER ROAD, COLUMBUS, OH 43224 (NAICS 236220). OSHA activity number 339681975.

What this inspection record means

OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch The Daimler Group — free Get an email when a new federal OSHA severe-injury report for The Daimler Group is published. One employer, no account, unsubscribe in one click.
Establishment
THE DAIMLER GROUP
Site address
3750 AGLER ROAD
City
COLUMBUS
State
OH
ZIP
43224
Mailing
1533 LAKE SHORE DRIVE, COLUMBUS, OH 43204
Inspection type
Planned (H)
Scope
Complete (A)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
236220
Employees
32
Ownership type
A

3 citations on file for this inspection.

1926.501 B14

Serious Gravity 5 3 instances 25 exposed
Issued
May 28, 2014
Penalty
Initial $3,500 · Current $1,750 Reduced
29 CFR 1926.501(b)(14): "Wall openings." Each employee working on, at, above, or near wall openings (including those with chutes attached) where the outside bottom edge of the wall opening is 6 feet (1.8 m) or more above lower levels and the inside bottom edge of the wall opening is less than 39 inches (1.0 m) above the walking/working surface, shall be protected from falling by the use of a guardrail system, a safety net system, or a personal fall arrest system.    a. On the second floor of area D where employees were working on the interior walls and ceiling, the window openings were not effectively guarded, thereby exposing employees to a 15 foot fall hazard.  b. On the second floor hallway between area B and D where employees were working on the interior walls, the window openings were not effectively guarded, thereby exposing employees to a 15 foot fall hazard.  c. On the second floor area B hallway adjacent to the gym where employees were working on the interior walls, the window opening to the gym was not effectively guarded, thereby exposing employees to a 15 foot fall hazard.
Recent events (2)
  • — I (S) $1750
  • — Z (S) $3500

1926.502 B02

Serious Gravity 5 1 instance 25 exposed
Issued
May 28, 2014
Penalty
Initial $0 · Current $0
29 CFR 1926.502(b)(2): Midrails, screens, mesh, intermediate vertical members, or equivalent intermediate structural members shall be installed between the top edge of the guardrail system and the walking/working surface when there is no wall or parapet wall at least 21 inches (53 cm) high.  a. On the second floor center ELA between area C and E where employees were working, the wall opening did not have a midrail installed, thereby exposing employees to a 15 foot fall hazard.
Recent events (2)
  • — I (S) $0
  • — Z (S) $0

1926.502 B01

Serious Gravity 5 1 instance 25 exposed
Issued
May 28, 2014
Penalty
Initial $7,000 · Current $3,500 Reduced
29 CFR 1926.502(b)(1): Top edge height of top rails, or equivalent guardrail system members, shall be 42 inches (1.1 m) plus or minus 3 inches (8 cm) above the walking/working level. When conditions warrant, the height of the top edge may exceed the 45-inch height, provided the guardrail system meets all other criteria of this paragraph.  Note: When employees are using stilts, the top edge height of the top rail, or equivalent member, shall be increased an amount equal to the height of the stilts.     a. On the second floor center ELA between area C and E where employees were working, the cable used as the top guardrail was installed at 36 inches high, thereby exposing employees to a 15 foot fall hazard.    The Daimler Group was previously cited for a violation of this occupational safety and health standard or its equivalent standard 29 CFR 1926.502(b)(1), which was contained in OSHA inspection number 98674, citation number 1, item number 1 and was affirmed as a final order on December 20, 2011 with respect to a workplace located at 4151 Bridgeway Avenue, Columbus, OH 43219.
Recent events (2)
  • — I (S) $3500
  • — Z (R) $7000

View The Daimler Group's full OSHA safety record →

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 339681975.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.