HOLLIS, NH ·
OSHA Inspection: C.L. GUILD CO., INC.
Complaint inspection · Safety discipline
At a glance
On , OSHA opened a complaint safety inspection of C.L. GUILD CO., INC. in MARY DRIVE, HOLLIS, NH 03049 (NAICS 238130). OSHA activity number 339740730.
OSHA opens inspections for many reasons: routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- C.L. GUILD CO., INC.
- Site address
- MARY DRIVE
- City
- HOLLIS
- State
- NH
- ZIP
- 03049
- Mailing
- PO BOX 676, WILTON, NH 03086
What kind of inspection was it?
- Inspection type
- Complaint (B)
- Scope
- Complete (A)
- Discipline
- Safety
- Advance notice
- No
- Union status
- Non-union (B)
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 238130
- Employees
- 2
- Ownership type
- Private (A)
Citations
4 citations on file for this inspection.
1926.451 B01
- Issued
- May 12, 2014
- Abate by
- May 16, 2014
- Penalty
- Initial $2,800 · Current $2,800
General-duty citation text
29 CFR 1926.451(b)(1): 29 CFR 1926.451(b)(1): Platform(s) on all working levels of scaffolds, were not fully planked or decked between the front uprights and guardrail supports such that the space between adjacent units, and the space between the platform and the uprights is no more than 1 inch (2.5 cm) wide, and the employer could not demonstrate that a wider space was necessary: (a) Job site - Employees were working from a twelve inch plank on a carpenter bracket scaffolding.
Recent events (2)
- · I (S) $2800
- · Z (S) $2800
1926.451 G01
- Issued
- May 12, 2014
- Abate by
- May 16, 2014
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1926.451(g)(1): 29 CFR 1926.451(g)(1): Each employee on a scaffold more than 10 feet above a lower level were not protected from falling to that lower level: (a) Job site - Employees were exposed to a fall hazard of up to 24' while working from a carpenter bracket scaffolding without fall protection.
Recent events (2)
- · I (S) $0
- · Z (S) $0
1926.501 B14
- Issued
- May 12, 2014
- Abate by
- May 16, 2014
- Penalty
- Initial $2,800 · Current $0 Reduced
General-duty citation text
29 CFR 1926.501(b)(14): The employer did not ensure that each employee working on, at, above, or near wall openings (including those with chutes attached) where the outside bottom edge of the wall opening was 6 feet (1.8 m) or more above lower levels and the inside bottom edge of the wall opening was less than 39 inches (1.0 m) above the walking/working surface, were not protected from falling by the use of a guardrail system, a safety net system, or a personal fall arrest system. (a) Job site - The window openings were not protected for fall hazards.
Recent events (2)
- · I (S) $0
- · Z (S) $2800
1926.1052 C01 I
- Issued
- May 12, 2014
- Abate by
- May 16, 2014
- Penalty
- Initial $2,800 · Current $0 Reduced
General-duty citation text
29 CFR 1926.1052(c)(1)(i): Stairways having four or more risers or rising more than 30 inches, whichever is less, were not equipped with one stairrail system along each unprotected side or edge: (a) Job site - The stairways were not guarded against falls.
Recent events (2)
- · I (S) $0
- · Z (S) $2800
More inspections in this industry (NAICS 238130)
More inspections in NH
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). OSHA publishes its own view of this case as inspection number 339740730.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.