OSHA Inspection: FASHION GLASS & MIRROR, LLC

Issued

Jul 31, 2014

Abate by

Sep 17, 2014

Penalty

Initial $4,900 · Current $4,900

General-duty citation text

29 CFR 1910.147(c)(4)(i): Procedures were not developed, documented and utilized for the control of potentially hazardous energy when employees were engaged in activities covered by this section:    This violation was discovered on June 12, 2014, at the job site located at 585 South I-35E, De Soto, Texas; where the employer did not develop equipment specific procedures for employees performing maintenance/repairs on machinery and/or equipment.

Issued

Jul 31, 2014

Abate by

Aug 26, 2014

Penalty

Initial $4,900 · Current $4,900

General-duty citation text

29 CFR 1910.178(l)(1)(i):  The employer did not certify that each operator has been trained and evaluated as required by this paragraph (l):    This violation was discovered on June 12, 2014, where at least one (1) employee operated a powered industrial truck without being trained and/or evaluated by the employer.

Issued

Jul 31, 2014

Abate by

Aug 12, 2014

Penalty

Initial $4,900 · Current $4,900

General-duty citation text

29 CFR 1910.212(a)(1):  One or more methods of machine guarding was not provided to protect the operator and other employees in the machine area from hazards such as those created by point of operation, ingoing nip points, rotating parts, flying chips and sparks:    This violation was observed on June 12, 2014, at the jobsite located at 585 South I-35E, De Soto, Texas; employees were not protected from point of operation, rotating parts, flying chips and sparks:  a) Fabrication Department, two (2) Delta drill presses (model #11-950, serial # W0040, 7-1/4-inch drill bit and model #11-950, serial #S-W0040 with ¼-inch drill bit);      b) Two (2) Jet Drill Presses (model #SDP-17MF, serial #7050056 and model #JDP17MF, serial #7050161, both with ½-inch drill bit);  c) Commercial Department Delta Shop Master Drill Press (model # S023666, serial #M-DP300 with 12-inch drill bit);  d) Horizontal table saw in the Commercial Department;  e) Shower Department Costruzioni Meccaniche Besana edging machine (model # R6V, serial #1680785) and the rotating belts.