Safety Incidents OSHA Severe Injury Reports · 2015–2025
4,113,118Inspections Most recent open 2026-07-13 Last loaded 2026-07-17

OSHA Inspection: SCI TECH AUTOMOTIVE*

Complaint inspection · Health discipline

On , OSHA opened a complaint health inspection of SCI TECH AUTOMOTIVE* in 9955 E 350 HIGHWAY, RAYTOWN, MO 64133 (NAICS 441310). OSHA activity number 339819922.

Watch SCI Tech Automotive* — free Get an email when a new federal OSHA severe-injury report for SCI Tech Automotive* is published. One employer, no account, unsubscribe in one click.
Site address
9955 E 350 HIGHWAY
City
RAYTOWN
State
MO
ZIP
64133
Mailing
9955 E 350 HIGHWAY, RAYTOWN, MO 64133
Inspection type
Complaint (B)
Scope
Partial (B)
Discipline
Health
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
441310
Employees
5
Ownership type
A

5 citations on file for this inspection.

1910.23 E01

Serious Gravity 10 1 instance 3 exposed
Issued
Abate by
Penalty
Initial $2800.00 · Current $1400.00 Reduced
29 CFR 1910.23(e)(1): Standard railing(s) did not consist of top rail, intermediate rail and/or posts and/or did not have a vertical height of 42 inches (106.7 cm) nominal from upper surface of top rail to floor, platform runway, or ramp level:  a)  At the "catwalk" - Employees were walking and manually carrying tires and/or other equipment across a platform (exposing employees to approximately 10ft fall hazards), which was missing an intermediate rail.      NOTE: IN ADDITION TO ABETMENT CERTIFICATION, THE EMPLOYER IS REQUIRED TO SUBMIT ABATEMENT DOCUMENTATION FOR THIS ITEM.  FAILURE TO COMPLY WILL RESULT IN AN ADDITIONAL PENALTY OF $1000.00 IN ACCORDANCE WITH 29 CFR 1903.19.
Recent events (2)
  • — I (S) $1400
  • — Z (S) $2800

1910.253 B04 I

Serious Gravity 5 1 instance 3 exposed
Issued
Abate by
Penalty
Initial $2400.00 · Current $1400.00 Reduced
29 CFR 1910.253(b)(4)(i): Oxygen cylinders were stored near highly combustible material, especially oil and grease; or near reserve stocks of carbide and acetylene or other fuel-gas cylinders, or near other substance likely to cause or accelerate fire:    a)  In the maintenance shop - Hydraulic oil/fluid was stored directly in front of oxygen cylinders connected to a low-flow manifold exposing employees to rapid/escalated fire hazards.          Abatement certification for this item is required.
Recent events (2)
  • — I (S) $1400
  • — Z (S) $2400

1910.253 E05 V

Serious Gravity 5 1 instance 3 exposed
Issued
Abate by
Penalty
Initial $2400.00 · Current $0.00 Reduced
29 CFR 1910.253(e)(5)(v): Hose showing leaks, burns, worn places, or other defects rendering it unfit for service were not repaired or replaced:    a)  In the maintenance shop - Employees were using oxygen/acetylene cutting torches with worn and/or damaged hoses and manifold connections causing oxygen to leak.              Abatement certification for this item is required.
Recent events (2)
  • — I (S) $0
  • — Z (S) $2400

1910.303 G02 I

Deleted Serious Gravity 10 1 instance 3 exposed
Issued
Abate by
Penalty
Initial $2800.00 · Current $0.00 Reduced
29 CFR 1910.303(g)(2)(i): Except as elsewhere required or permitted by Subpart S of Part 1910, live parts of electric equipment operating  at 50 volts or more were not guarded against accidental contact by use of approved cabinets or other forms of approved enclosures or by any of the means identified in paragraphs (A), (B), (C), and (D) of 29 CFR 1910.303(g)(2)(i):  a)  At the maintenance shop - Employees were working near unprotected electrical wiring (~240 volts / 100 amperes), which was exposing bare wires, where a car lift had been previously removed.      NOTE: IN ADDITION TO ABETMENT CERTIFICATION, THE EMPLOYER IS REQUIRED TO SUBMIT ABATEMENT DOCUMENTATION FOR THIS ITEM.  FAILURE TO COMPLY WILL RESULT IN AN ADDITIONAL PENALTY OF $1000.00 IN ACCORDANCE WITH 29 CFR 1903.19.
Recent events (2)
  • — I (S) $0
  • — Z (S) $2800

1910.1200 E01

Other-than-serious 1 instance 3 exposed
Issued
Abate by
Penalty
Initial $1200.00 · Current $0.00 Reduced
29 CFR 1910.1200(e)(1): The employer did not develop, implement, and/or maintain at the workplace a written hazard communication program which describes how the criteria specified in 29 CFR 1910.1200(f), (g), and (h) will be met:      a)  Throughout the maintenance shop - Employees were using hazardous chemicals (such as, but not limited to: hydraulic oil, hydraulic fluid, brake cleaner, white lithium grease, battery cleaner, and other automotive fluids) and the employer had not developed nor implemented a written hazard communication program which described how the criteria for labels and other forms of warning, material safety data sheets, and employee information and training would be met.            Abatement certification for this item is required.
Recent events (2)
  • — I (O) $0
  • — Z (S) $1200

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 339819922.