Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,992Inspections Most recent open 2026-07-18 Last loaded 2026-07-22

OSHA Inspection: INTERNATIONAL FIBER CORP.

Complaint inspection · Safety discipline

On , OSHA opened a complaint safety inspection of INTERNATIONAL FIBER CORP. in 50 BRIDGE STREET, NORTH TONAWANDA, NY 14120 (NAICS 325221). OSHA activity number 339871857.

What this inspection record means

OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch International Fiber Corp. — free Get an email when a new federal OSHA severe-injury report for International Fiber Corp. is published. One employer, no account, unsubscribe in one click.
Site address
50 BRIDGE STREET
City
NORTH TONAWANDA
State
NY
ZIP
14120
Mailing
50 BRIDGE STREET, NORTH TONAWANDA, NY 14120
Inspection type
Complaint (B)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
A
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
325221
Employees
48
Ownership type
A

4 citations on file for this inspection.

5(a)(1)

Serious Gravity 5 1 instance 6 exposed
Issued
Sep 24, 2014
Abate by
Oct 25, 2014
Penalty
Initial $5,000 · Current $3,500 Reduced
OSH ACT of 1970 Section (5)(a)(1):  Section 5 (a) (1) of the Occupational Safety and Health Act of 1970:     a) The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees working in the Chilsonator Mill area when they were exposed to death caused from the fire and explosion hazard when they "ran the (Chilsonator roller seals) to failure" by not establishing an adequate preventative maintenance program.         ABATEMENT DOCUMENTATION REQUIRED      Among other methods, several feasible and acceptable abatement methods to correct this hazard include; following the Preventive Maintenance Guide described in Section 9 of the Chilsonator Operating Manual 12x12 ver 1.     Section 9 of the Operating Manual states:  The following information is intended a guideline for the development of an adequate preventative maintenance program for this machine.  Modifications to recommended intervals or activities may be necessary due to special condition, frequency of operations or in-plant requirements.  All changes should be documented by plant personnel.      Recommend frequency for the Roll Seals & Housing Area indicated: monthly inspection of the side seals for excessive wear and damage with instructions to replace if worn > 3mm deep ( 1/8 inch ) or damaged.   Six month inspection of the top seals for excessive wear or damage with instructions to replace if appears worn or damaged.
Recent events (2)
  • — I (S) $3500
  • — Z (S) $5000

1910.22 A01

Serious Gravity 5 1 instance 6 exposed
Issued
Sep 24, 2014
Penalty
Initial $5,000 · Current $3,500 Reduced
29 CFR 1910.22(a)(1): All places of employment, passageways, storerooms, and service rooms shall be kept clean and orderly and in a sanitary condition.    a) On or about 07/28/14 in the Chilsonator mill area; employer failed to keep the area clean by allowing dust ( primarily cellulose - explosive dust ) to accumulate on the horizontal surfaces, such as but not limited to, hydraulic pump cover, roll seal assembly cover, roller drive cover, dust collector frame, mezzanine beams, to a depth greater than 1/8 inch.      NO ABATEMENT CERTIFICATION REQUIRED
Recent events (2)
  • — I (S) $3500
  • — Z (S) $5000

1910.23 A02

Deleted Serious Gravity 5 1 instance 6 exposed
Issued
Sep 24, 2014
Abate by
Oct 10, 2014
Penalty
Initial $5,000 · Current $0 Reduced
29 CFR 1910.23(a)(2): Ladderway floor opening(s) or platform(s) were not guarded by a standard railing with standard toeboard(s) on all exposed sides (except at the entrance to opening) with passage through the railing either provided with a swinging gate or so offset that a person could walk directly into the opening:  a) On or about 07/28/14 on the mezzanine in the Chilsonator mill area; employer failed to protect employees who work in this area from falls when they installed a manual drop down bar to protect the ladder way opening.    ABATEMENT CERTIFICATION REQUIRED
Recent events (2)
  • — I (S) $0
  • — Z (S) $5000

1910.23 A08

Serious Gravity 5 1 instance 6 exposed
Issued
Sep 24, 2014
Penalty
Initial $3,400 · Current $2,200 Reduced
29 CFR 1910.23(a)(8): Every floor hole into which persons can accidentally walk were not guarded:    a) On or about 07/28/14 on the mezzanine in the Chilsonator mill area; employer failed to protect employees who work in this area from falls when there was a floor hole measuring 8 inches wide by 4 feet 7 inches long in the area south of the ladder landing.        NO ABATEMENT CERTIFICATION REQUIRED
Recent events (2)
  • — I (S) $2200
  • — Z (S) $3400

View International Fiber Corp.'s full OSHA safety record →

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 339871857.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.