DEERFIELD, OH ·
OSHA Inspection: DEERFIELD FARMS SERVICE INC
Planned inspection · Health discipline
At a glance
On , OSHA opened a planned health inspection of DEERFIELD FARMS SERVICE INC in 9041 ROUTE 224, DEERFIELD, OH 44411 (NAICS 424510). OSHA activity number 339899627.
OSHA opens inspections for many reasons: routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- DEERFIELD FARMS SERVICE INC
- Site address
- 9041 ROUTE 224
- City
- DEERFIELD
- State
- OH
- ZIP
- 44411
- Mailing
- PO BOX 155, DEERFIELD, OH 44411
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Complete (A)
- Discipline
- Health
- Advance notice
- No
- Union status
- Non-union (B)
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 424510
- Employees
- 55
- Ownership type
- Private (A)
Citations
7 citations on file for this inspection.
1910.272 D
- Issued
- Sep 16, 2014
- Abate by
- Jan 19, 2015
- Penalty
- Initial $2,380 · Current $1,666 Reduced
General-duty citation text
29 CFR 1910.272(d): The employer did not develop and implement an emergency action plan meeting the requirements contained in 1910.38(a): Refer to 29 CFR 1910.38(d) which requires an alarm system in compliance with �1910.165: No alarm system was installed to allow notice to all employees in all buildings on the site of an emergency.
Recent events (2)
- · I (S) $1666
- · Z (S) $2380
1910.219 C04 I
- Issued
- Sep 16, 2014
- Abate by
- Sep 24, 2014
- Penalty
- Initial $1,785 · Current $1,250 Reduced
General-duty citation text
29 CFR 1910.219(c)(4)(i): Unguarded projecting shaft end(s) did not present a smooth edge and end and projected more than one half the diameter of the shaft: There was a vertical projecting shaft on the top of the Bridgeport drill press.
Recent events (2)
- · I (S) $1249.5
- · Z (S) $1785
1910.303 B02
- Issued
- Sep 16, 2014
- Abate by
- Oct 4, 2014
- Penalty
- Initial $1,785 · Current $1,250 Reduced
General-duty citation text
29 CFR 1910.303(b)(2): Listed or labeled electrical equipment was not used or installed in accordance with instructions included in the listing or labeling: In the elevator storage shed, there was an exterior lamp which was wired into the shed wiring through a connection to nonmetallic sheathed cable (NMSC). The splice, which was wrapped with tape, was not contained in an electrical box.
Recent events (2)
- · I (S) $1249.5
- · Z (S) $1785
1910.134 C01
- Issued
- Sep 16, 2014
- Abate by
- Dec 4, 2014
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1910.134(c)(1): A written respiratory protection program that included the provisions in 1910.134(c)(1)(i) - (ix) with worksite specific procedures was not established and implemented for required respirator use: Respirators are required when employees enter grain bins to clean out residual grain; no written program was developed.
Recent events (2)
- · I (O) $0
- · Z (O) $0
1910.134 E01
- Issued
- Sep 16, 2014
- Abate by
- Dec 4, 2014
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1910.134(e)(1): The employer did not provide a medical evaluation to determine the employees ability to use a respirator, before the employee was fit tested or required to use the respirator in the workplace: Respirators are required when employees enter grain bins to clean out residual grain; no medical evaluations were done.
Recent events (2)
- · I (O) $0
- · Z (O) $0
1910.134 F01
- Issued
- Sep 16, 2014
- Abate by
- Dec 4, 2014
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1910.134(f)(1): The employer did not ensure that employees using a tight-fitting facepiece respirator pass an appropriate qualitative fit test (QLFT) or quantitative fit test (QNFT) as stated in 29 CFR 1910(f): Respirators are required when employees enter grain bins to clean out residual grain; no fit testing was done.
Recent events (2)
- · I (O) $0
- · Z (O) $0
1910.134 K01
- Issued
- Sep 16, 2014
- Abate by
- Dec 4, 2014
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1910.134(k)(1): The employer did not ensure that each employee can demonstrate knowledge of at least 29 CFR 1910.134(h)(1)(i) through(vii): Respirators are required when employees enter grain bins to clean out residual grain; no respirator training was done.
Recent events (2)
- · I (O) $0
- · Z (O) $0
More inspections in this industry (NAICS 424510)
More inspections in OH
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). OSHA publishes its own view of this case as inspection number 339899627.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.