BRONX, NY ·
OSHA Inspection: DELICIOSO COCO HELADO,INC.
Referral inspection · Safety discipline
At a glance
On , OSHA opened a referral safety inspection of DELICIOSO COCO HELADO,INC. in 849 ST ANN'S AVE, BRONX, NY 10456 (NAICS 312113). OSHA activity number 339961492.
OSHA opens inspections for many reasons: routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- DELICIOSO COCO HELADO,INC.
- Site address
- 849 ST ANN'S AVE
- City
- BRONX
- State
- NY
- ZIP
- 10456
- Mailing
- 849 ST ANN'S AVE, BRONX, NY 10456
What kind of inspection was it?
- Inspection type
- Referral (C)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- Non-union (B)
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 312113
- Employees
- 15
- Ownership type
- Private (A)
Citations
1 citation on file for this inspection.
5(a)(1)
- Issued
- Mar 19, 2015
- Abate by
- Apr 14, 2015
- Penalty
- Initial $7,000 · Current $0 Reduced
General-duty citation text
OSH ACT of 1970 Section (5)(a)(1): The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that, employees were exposed to crushing hazard: a) Location: 849 St. Ann's Ave, Bronx, NY, 10456, Driveway: Employee was exposed to a hazard of crushing injury/death when passing under an industrial motorized roll-up door, while moving garbage bins, on or about 9/19/14. AMONG OTHER FEASIBLE METHODS OF ABATEMENT WOULD INCLUDE THE FOLLOWING: 1) Installation of a reversing edge switch. This would allow an automatic closing control out of sight of the door, but would immediately reverse the direction of the door upon striking an obstruction. 2) A constant pressure actuation switch. This would always be operated in sight of the doors so that it could be released and manually reversed if an obstruction was hit. 3) A three-button control switch. If the following conditions are met: a) It is provided with a permanent placard adjacent to the switch with the following warning letters at least 1/4" high: Warning to prevent entrapment do not start the door downward unless the doorway is clear b) The control station and placard are located within sight of the doorway. c) Automatic closing controls are not also installed. d) Operator must remain at the control station and observe the door until the door is fully closed. 4) Train employees in the safe operation of overhead doors and ensure that no employees are allowed to pass beneath the door while it is in motion.
Recent events (2)
- · I (S) $0
- · Z (S) $7000
More inspections in this industry (NAICS 312113)
More inspections in NY
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). OSHA publishes its own view of this case as inspection number 339961492.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.