Safety Incidents OSHA Severe Injury Reports · 2015–2025
4,113,118Inspections Most recent open 2026-07-13 Last loaded 2026-07-17

OSHA Inspection: BROOKE CROSBY

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of BROOKE CROSBY in 7937 BUONA SERA, SPRINGDALE, AR 72762 (NAICS 238130). OSHA activity number 340046333.

Watch Brooke Crosby — free Get an email when a new federal OSHA severe-injury report for Brooke Crosby is published. One employer, no account, unsubscribe in one click.
Establishment
BROOKE CROSBY
Site address
7937 BUONA SERA
City
SPRINGDALE
State
AR
ZIP
72762
Mailing
12968 GAILEY HOLLOW RD, SILOAM SPRINGS, AR 72761
Inspection type
Planned (H)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
238130
Employees
10
Ownership type
A

4 citations on file for this inspection.

1926.100 A

Serious Gravity 5 1 instance 2 exposed
Issued
Abate by
Penalty
Initial $1600.00 · Current $250.00 Reduced
29 CFR 1926.100(a): Employees working in areas where there was a possible danger of head injury from impact, or falling or flying objects, or from electrical shock and burns, were not protected by protective helmets:    On or about October 29, 2014, at the job site located at 7937 Buona Sera in Springdale, Arkansas, where employees were framing a new single story residence, employees working below the employees erecting rafters were not wearing hard hats. These conditions exposed the employees to the hazard of being stuck by falling objects.
Recent events (2)
  • — I (S) $250
  • — Z (S) $1600

1926.451 B05 II

Serious Gravity 5 1 instance 1 exposed
Issued
Abate by
Penalty
Initial $2000.00 · Current $250.00 Reduced
29 CFR 1926.451(b)(5)(ii): The end of a platform greater than 10 feet in length extended over its support more than 18 inches and the platform was not designed and installed so that the cantilevered portion of the platform is able to support employees without tipping, or has guardrails which block employee access to the cantilevered end:    On or about October 29, 2014, at the job site located at 7937 Buona Sera in Springdale, Arkansas, were employees were erecting rafters for a new single story residence, employees were working  from a supported scaffold that extended approximately 5 feet over its supports at both ends. The platform was neither secured so the cantilevered end could support employees without tipping nor did it have guard rails to prevent employees from accessing the cantilevered ends. These conditions exposed employees to the hazard of falling approximately 16 feet to the concrete floor below.
Recent events (2)
  • — I (S) $250
  • — Z (S) $2000

1926.451 G01

Serious Gravity 5 1 instance 1 exposed
Issued
Abate by
Penalty
Initial $2000.00 · Current $0.00 Reduced
29 CFR 1926.451(g)(1): Each employee on a scaffold more than 10 feet above a lower level were not protected from falling to that lower level:    On or about October 29, 2014, at the job site located at 7937 Buona Sera in Springdale, Arkansas, where employees were framing a new single story residence, employees were working from a supported scaffold to while erecting rafters over the living area. The scaffold did not gave guard rails or nets and the employees were not using personal fall protection equipment. These conditions exposed the employees to the hazard of falling approximately 16 feet to the concrete floor below.
Recent events (2)
  • — I (S) $0
  • — Z (S) $2000

1926.501 B13

Serious Gravity 10 1 instance 1 exposed
Issued
Abate by
Penalty
Initial $2800.00 · Current $250.00 Reduced
29 CFR 1926.501(b)(13): Each employee engaged in residential construction activities 6 feet (1.8 m)  or more above lower levels was not protected by guardrail systems, safety net systems, personal fall arrest systems, or an alternative fall protection measure under another provision of paragraph 1926.501 (b), nor did the employer demonstrate that it is infeasible or creates a greater hazard to use these systems and develop and implement a fall protection plan which meets the requirements of paragraph (k) of section 1926.502:    On or about October 29, 2014, at the job site located at 7937 Buona Sera in Springdale, Arkansas, were employees were framing a new single story residence, employees were erecting rafters above the garage. The employees were standing on the edge of the ceiling joists and the top plates and were not using any form of fall protection. These conditions exposed the employees to the hazard of falling approximately 10 feet to the concrete floor below.
Recent events (2)
  • — I (S) $250
  • — Z (S) $2800

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 340046333.