KINGSTON, NY ·
OSHA Inspection: LIBOLT & SONS, INC.
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of LIBOLT & SONS, INC. in 165 CORNELL STREET, KINGSTON, NY 12401 (NAICS 236116). OSHA activity number 340064351.
OSHA opens inspections for many reasons: routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- LIBOLT & SONS, INC.
- Site address
- 165 CORNELL STREET
- City
- KINGSTON
- State
- NY
- ZIP
- 12401
- Mailing
- 15 STEVE'S LANE, GARDINER, NY 12525
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Complete (A)
- Discipline
- Safety
- Advance notice
- No
- Union status
- B
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 236116
- Employees
- 15
- Ownership type
- A
Citations
6 citations on file for this inspection.
1926.451 G01 VII
- Issued
- Dec 19, 2014
- Penalty
- Initial $2,000 · Current $1,500 Reduced
General-duty citation text
29 CFR 1926.451(g)(1)(vii): Each employee on a scaffold, not otherwise specified in paragraphs (g)(1)(i) through (g)(1)(vi) of this section, more than 10 feet (3.1 m) above lower level was not protected from falls by the use of personal fall arrest systems or guardrail systems meeting the requirements of paragraph (g)(4) of this section: (a) Left Side of the Building - on or about November 5, 2014 - a guardrail system was not installed on the front section of the field-fabricated scaffold platform.
Recent events (2)
- · I (S) $1500
- · Z (S) $2000
1926.501 B13
- Issued
- Dec 19, 2014
- Penalty
- Initial $2,000 · Current $1,500 Reduced
General-duty citation text
29 CFR 1926.501(b)(13): Each employee(s) engaged in residential construction activities 6 feet (1.8 m) or more above lower levels were not protected by guardrail systems, safety net system, or personal fall arrest system, nor were employee(s) provided with an alternative fall protection measure under another provision of paragraph 1926.501(b): (a) Left Side of the Building, Second Story Floor - on or about November 5, 2014 - no fall protection was available for the employee that was removing debris at a door opening. Elevation to the ground was approximately 34 feet, 6 inches.
Recent events (2)
- · I (S) $1500
- · Z (S) $2000
1926.502 B01
- Issued
- Dec 19, 2014
- Penalty
- Initial $1,600 · Current $1,200 Reduced
General-duty citation text
29 CFR 1926.502(b)(1): The top edge height of the top rails, or equivalent guardrail system members, was not 42 inches (1.1 m) plus or minus 3 inches (8 cm) above the walking/working level: (a) Center Stairwell - on or about November 6, 2014 - the top guardrail height exceeded the maximum allowable height. Elevation to the lower level was approximately 8 feet, 10 inches.
Recent events (2)
- · I (S) $1200
- · Z (S) $1600
1926.502 B02
- Issued
- Dec 19, 2014
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1926.502(b)(2): Midrails, screens, mesh, intermediate vertical members, or equivalent intermediate structure members were not installed between the top edge of the guardrail system and the walking/working surface when there was no wall or parapet wall at least 21 inches (53 cm) high: (a) Center Stairwell - on or about November 6, 2014 - the midrail that was installed for this opening was not attached to the right side of this opening. Elevation to the lower level was approximately 8 feet, 10 inches.
Recent events (2)
- · I (S) $0
- · Z (S) $0
1926.503 A01
- Issued
- Dec 19, 2014
- Penalty
- Initial $2,000 · Current $1,500 Reduced
General-duty citation text
29 CFR 1926.503(a)(1): The employer did not provide a training program for each employee potentially exposed to fall hazards to enable each employee to recognize the hazards of falling and the procedures to be followed in order to minimize these hazards: (a) Left Side of the Building, Second Story Floor - on or about November 5, 2014 - the employer did not provide comprehensive fall protection training to employees that were performing carpentry and masonry work on site. Employees were exposed to fall hazards ranging between 8 feet, 10 inches to 34 feet, 6 inches.
Recent events (2)
- · I (S) $1500
- · Z (S) $2000
1910.178 L01 I
- Issued
- Dec 19, 2014
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1910.178(l)(1)(i): The employer did not ensure that each powered industrial truck operator is competent to operate a powered industrial truck safely, as demonstrated by the successful completion of the training and evaluation specified in this paragraph (l): (a) Jobsite- on or about November 5, 2014 - the employer did not ensure that the operator of the Skytrak 8042, serial# 0160061772, Rough Terrain Telescopic Material Handling Lift was a competent operator, and certified in the operation of this equipment.
Recent events (2)
- · I (O) $0
- · Z (O) $0
More inspections at Libolt & Sons, INC.
View Libolt & Sons, INC.'s full OSHA safety record →
More inspections in this industry (NAICS 236116)
More inspections in NY
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 340064351.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.