ELMSFORD, NY ·
OSHA Inspection: EVENING OUT, INC.
Complaint inspection · Safety discipline
At a glance
On , OSHA opened a complaint safety inspection of EVENING OUT, INC. in 1 BROADWAY PLAZA, ELMSFORD, NY 10523 (NAICS 711110). OSHA activity number 340176601.
OSHA opens inspections for many reasons: routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- EVENING OUT, INC.
- Site address
- 1 BROADWAY PLAZA
- City
- ELMSFORD
- State
- NY
- ZIP
- 10523
- Mailing
- 1 BROADWAY PLAZA, ELMSFORD, NY 10523
What kind of inspection was it?
- Inspection type
- Complaint (B)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- B
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 711110
- Employees
- 70
- Ownership type
- A
Citations
2 citations on file for this inspection.
5(a)(1)
- Issued
- Feb 20, 2015
- Penalty
- Initial $4,900 · Current $4,900
General-duty citation text
OSH ACT of 1970 Section (5)(a)(1): Section 5(a)(1) of the Occupational Safety and Health Act of 1970: the employer did not furnish employment and a place of employment which was free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to fall hazards: on or about: 11/10/14 Location: Main theatre a) Employees were elevated up to approximately 20ft, using a Genie (PLC-24) Personnel Lift, without stabilizing the lift with the four outriggers as required by the manufacturers operator's manual. Among other methods, the feasible and acceptable abatement method to correct this hazard is to: 1) Follow the PLC-24 Genie Lift, Operator's Manual safety rules, page 2. Tip-over Hazards. Do not raise the platform unless all four correct length outriggers are properly installed, stabilizers are locked (30 & 36 models), foot pads firmly contact ground and the base is level. 2) Follow the ANSI/SIA A92.3-2006 standards for Manually Propelled Elevating Aerial Platforms, page 30, 7.10 (3) Operator Warning and Instruction. Deployment of stability enhancing means. Outriggers, stabilizers, extendible axles, axle locks or other stability enhancing means shall be deployed and locked into place as required by the manufacturer.
Recent events (1)
- · Z (S) $4900
1910.23 C01
- Issued
- Feb 20, 2015
- Penalty
- Initial $4,900 · Current $4,900
General-duty citation text
29 CFR 1910.23(c)(1): Open-sided floor or platforms 4 feet or more above adjacent floor or ground level were not guarded by a standard railing (or the equivalent as specified in paragraph (e)(3) of this section) and toeboards. location: Main Theatre on or about: 11/12/14 a) The employer did not provide an adequate guard rail system or fall protection along sections of the catwalk. Employees exposed to falls of approximately 25ft.
Recent events (1)
- · Z (S) $4900
More inspections in this industry (NAICS 711110)
More inspections in NY
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 340176601.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.