SALEM, OR —
OSHA Inspection: ARMY NATIONAL GUARD
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of ARMY NATIONAL GUARD in 1921 TURNER RD S.E., SALEM, OR 97302 (NAICS 481219). OSHA activity number 340203470.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- ARMY NATIONAL GUARD
- Site address
- 1921 TURNER RD S.E.
- City
- SALEM
- State
- OR
- ZIP
- 97302
- Mailing
- 1921 TURNER RD S.E., SALEM, OR 97302
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Complete (A)
- Discipline
- Safety
- Advance notice
- No
- Union status
- A
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 481219
- Employees
- 40
- Ownership type
- D
Citations
3 citations on file for this inspection.
1910.23 C01
- Issued
- Apr 13, 2015
- Abate by
- May 7, 2015
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1910.23(c)(1): Open-sided floors and/or platforms four feet or more above adjacent floor or ground level were not guarded with standard railings (or equivalent) and toeboards: Note: Toeboards are only required when persons can pass, there is moving equipment or there is equipment with which falling materials could create a hazard. Hangar#2- The mobile tail rotor maintenance platform was not equipped with mid rails, exposing mechanics to falls of 7'3".
Recent events (1)
- — Z (S) $0
1910.215 B09
- Issued
- Apr 13, 2015
- Abate by
- May 7, 2015
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1910.215(b)(9): The distance between the abrasive wheel periphery(s) and the adjustable tongue or the end of the safety guard peripheral member at the top exceeded one fourth inch: Shop Area- (a) The Dayton bench grinder's distance between the tongue guard and abrasive wheel was measured to be 15/16 of an inch.
Recent events (1)
- — Z (S) $0
1910.253 E01
- Issued
- Apr 13, 2015
- Abate by
- May 7, 2015
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1910.253(e)(1): Equipment was not installed and used only in the service for which it was approved and as recommended by the manufacturer: Shop Area- (a) The oxygen regulator used for brazing and other torch work was not functioning correctly and would not indicate zero pressure when turned off.
Recent events (1)
- — Z (S) $0
More inspections at Army National Guard
View Army National Guard's full OSHA safety record →
More inspections in this industry (NAICS 481219)
More inspections in OR
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 340203470.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.