OSHA Inspection: DEANGELO DEVELOPMENT, INC.

Issued

2015-07-02 00:00:00

Abate by

2015-07-15 00:00:00

Penalty

Initial $2800.00 · Current $1600.00 Reduced

General-duty citation text

29 CFR 1926.451(b)(1): Each platform on all working levels of scaffolds was not fully planked or decked between the front uprights and the guardrail supports as specified in paragraphs 1926.451(b)(1)(i)-(ii).    a.) On or about January 28, 2015, at the above addressed job site, employees were exposed to a fall hazard of approximately 12 feet, while performing carpentry work on fabricated frame scaffolds that were not fully planked.

Issued

2015-07-02 00:00:00

Abate by

2015-07-15 00:00:00

Penalty

Initial $2800.00 · Current $1600.00 Reduced

General-duty citation text

29 CFR 1926.451(c)(2): Supported scaffold poles, legs, posts, frames,  or uprights did not bear on base plates, mud sills or other adequate firm foundation:    a.) On or about January 28, 2015, at the above addressed job site, employees were exposed to a scaffold displacement hazard while performing carpentry work on a fabricated frame scaffolds that did not have base plates and mud sills.

Issued

2015-07-02 00:00:00

Abate by

2015-07-15 00:00:00

Penalty

Initial $2800.00 · Current $1600.00 Reduced

General-duty citation text

29 CFR 1926.451(e)(1): When scaffold platforms were more than 2 feet (0.6 m) above or below a point of access, portable ladders, hook-on ladders, attachable ladders, stair towers (scaffold stairways/towers), stairway-type ladders (such as ladder stands), ramps, walkways, integral prefabricated scaffold access, or direct access from other scaffold, stucture, personnel hoist, or similar surface was not used.  End rails were used as a means of access.    a.)  On or about January 28, 2015, at the above addressed job site, employees were exposed to a fall hazard of approximately 12 feet, while performing carpentry work on a fabricated frame scaffold which was not equipped with access ladders.

Issued

2015-07-02 00:00:00

Abate by

2015-07-15 00:00:00

Penalty

Initial $2800.00 · Current $1600.00 Reduced

General-duty citation text

29 CFR 1926.451(f)(3): Scaffolds and scaffold components shall be inspected for visible defects by a competent person before each work shift, and after any occurrence which could affect a scaffold's structural integrity.    a.)  On or about January 28, 2015, at the above addressed job site, employees were exposed to a fall and scaffold displacement hazards while performing carpentry work on a fabricated frame scaffold that had not been inspected by a competent person that lacked planking, guardrails, base plates, mudsills, and access ladders.

Issued

2015-07-02 00:00:00

Abate by

2015-07-15 00:00:00

Penalty

Initial $2800.00 · Current $1600.00 Reduced

General-duty citation text

29 CFR 1926.451(g)(1): Employees on scaffolds more than 10 feet (3.1 m) above a lower level were not protected from falling to that lower level by fall protection established in paragraphs (g)(1)(i)-(vii) of this section:    a.)  On or about January 28, 2015, at the above addressed job site, employees were exposed to a fall hazard of approximately 12 feet, while performing carpentry work on a fabricated frame scaffold that lacked guardrails without a means of conventional fall protection.

Issued

2015-07-02 00:00:00

Abate by

2015-07-15 00:00:00

Penalty

Initial $2000.00 · Current $1200.00 Reduced

General-duty citation text

29 CFR 1926.454(a): The employer did not have each employee who performed work while on a scaffold trained by a person qualified in the subject matter to recognize the hazards associated with the type of scaffold being used and to understand the procedures to control or minimize those hazards.    a.)  On or about January 28, 2015, at the above addressed job site, the employer did not provide training to employees who had performed carpentry work from scaffolds that lacked guardrails and a means of conventional fall protection and were exposed to a fall hazard of approximately 12 feet.