FAIRLESS HILLS, PA —
OSHA Inspection: SALESMASTER CORP.
Complaint inspection · Safety discipline
At a glance
On , OSHA opened a complaint safety inspection of SALESMASTER CORP. in 87 TOWPATH RD, FAIRLESS HILLS, PA 19030 (NAICS 423840). OSHA activity number 340265081.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- SALESMASTER CORP.
- Site address
- 87 TOWPATH RD
- City
- FAIRLESS HILLS
- State
- PA
- ZIP
- 19030
- Mailing
- 87 TOWPATH RD, FAIRLESS HILLS, PA 19030
What kind of inspection was it?
- Inspection type
- Complaint (B)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- B
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 423840
- Employees
- 25
- Ownership type
- A
Citations
5 citations on file for this inspection.
5(a)(1)
- Issued
- Feb 24, 2015
- Abate by
- Mar 28, 2015
- Penalty
- Initial $2,800 · Current $2,100 Reduced
General-duty citation text
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing for likely to cause death or serious physical harm to employees in that employees were exposed to falls from being lifted on the forks of the forklift: a) Warehouse - On or about February 4, 2015, employees were being raised on the forks of the Raymond High reach forklift and Clark forklift to access the upper level of the racking system. Among other methods, a feasible and acceptable means to abate these hazards is to follow ITSDF B56.1-2005 entitled, "Safety Standard for Low Lift and High Lift Trucks," Section 4.17 Elevating Personnel, which states, "Only operator-up high lift trucks have been designed to lift personnel. If a work platform is used on trucks designed and intended for handling materials, the requirements of paragraphs 4.17.2 and 4.17.3 shall be met for the protection of personnel."
Recent events (2)
- — I (S) $2100
- — Z (S) $2800
1910.132 A
- Issued
- Feb 24, 2015
- Abate by
- Mar 28, 2015
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1910.132(a): Protective equipment was not used when necessary whenever hazards capable of causing injury and impairment were encountered: a) Warehouse - On or about February 4, 2015, employees were working from the various levels of the racking system, at heights between five and 15 feet above the floor level, without any means of fall protection.
Recent events (2)
- — I (S) $0
- — Z (S) $0
5(a)(1)
- Issued
- Feb 24, 2015
- Abate by
- Mar 28, 2015
- Penalty
- Initial $2,800 · Current $2,100 Reduced
General-duty citation text
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees are exposed to rack collapse from damage and unsecured to the storage racking system posts. a) Warehouse - On or about February 4, 2015, storage rack posts are damaged from being struck by forklifts and not taken out of service and repaired. b) Warehouse - On or about February 4, 2015, storage rack legs are not secured to the floor with bolts to prevent displacement. Among other methods, a feasible and acceptable means to abate these hazards is to follow ANSI Ng16,1-2008 entitled, "Specification for the Design, Testing, and Utilization of Industrial Steel Storage Racks," Section 1.4.7, Column Base Plates, which states "The bottom of all columns shall be furnished with column base plates, as specified in Section 7.2. All rack columns shall be anchored to the floor with anchor bolts capable of resisting the forces caused by the horizontal and vertical loads on the rack and Anchors," and 1.4.9, Rack Damage, which states "Upon any visible damage, the pertinent portions of the rack shall be unloaded immediately by the user until the damaged portion is repaired or replaced."
Recent events (2)
- — I (S) $2100
- — Z (S) $2800
1910.178 L05
- Issued
- Feb 24, 2015
- Abate by
- Mar 28, 2015
- Penalty
- Initial $2,000 · Current $1,500 Reduced
General-duty citation text
29 CFR 1910.178(l)(5): The employer did not evaluate the competency of the operator who had previously received training appropriate to the truck and working conditions encountered. a) Warehouse - On or about February 4, 2015, the employer did not certify that employees with prior forklift training were visually observed operating forklifts prior to their initial use.
Recent events (2)
- — I (S) $1500
- — Z (S) $2000
1910.178 M03
- Issued
- Feb 24, 2015
- Abate by
- Mar 28, 2015
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1910.178(m)(3): Unauthorized personnel shall not be permitted to ride on powered industrial trucks. A safe place to ride shall be provided where riding of trucks is authorized. a) Warehouse - On or about February 4, 2015, employees were riding upon and being raised by the forks of the Raymond High reach forklift and Clark forklift to access the upper level of the racking system without being provided a proper lifting platform or place to ride.
Recent events (2)
- — I (S) $0
- — Z (S) $0
More inspections in this industry (NAICS 423840)
More inspections in PA
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 340265081.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.