Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,992Inspections Most recent open 2026-07-18 Last loaded 2026-07-22

OSHA Inspection: SUPERIOR WIRE AND METAL SPEC.

Complaint inspection · Health discipline

On , OSHA opened a complaint health inspection of SUPERIOR WIRE AND METAL SPEC. in 205 FOURTH STREET, PERRYSBURG, OH 43551 (NAICS 332618). OSHA activity number 340372226.

What this inspection record means

OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch Superior Wire and Metal Spec. — free Get an email when a new federal OSHA severe-injury report for Superior Wire and Metal Spec. is published. One employer, no account, unsubscribe in one click.
Site address
205 FOURTH STREET
City
PERRYSBURG
State
OH
ZIP
43551
Mailing
205 FOURTH STREET, PERRYSBURG, OH 43551
Inspection type
Complaint (B)
Scope
Partial (B)
Discipline
Health
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
332618
Employees
63
Ownership type
A

4 citations on file for this inspection.

1910.134 C01

Serious Gravity 1 1 instance 1 exposed
Issued
May 14, 2015
Abate by
Jun 9, 2015
Penalty
Initial $2,100 · Current $2,100

Hazardous substances 1520

29 CFR 1910.134(c)(1): A written respiratory protection program that included the provisions in 29 CFR 1910.134(c)(1)(i) - (ix) with worksite specific procedures was not established and implemented for required respirator use:     1.) On or about February 10, 2015, the employer did not develop and implement a written respiratory protection program which covered employees who were required to wear a dust mask respirator while performing plasma cutting.
Recent events (1)
  • — Z (S) $2100

1910.134 E01

Serious Gravity 1 1 instance 1 exposed
Issued
May 14, 2015
Abate by
Jun 9, 2015
Penalty
Initial $0 · Current $0

Hazardous substances 1520

29 CFR 1910.134(e)(1): The employer did not provide a medical evaluation to determine the employee's ability to use a respirator, before the employee was fit tested or required to use the respirator in the workplace:       1.) On or about February 10, 2015, the employer failed to provide employees who were required to wear dust masks during plasma cutting operations a medical evaluation to determine if the employees were fit to wear a respirator.
Recent events (1)
  • — Z (S) $0

1910.134 F01

Serious Gravity 1 1 instance 1 exposed
Issued
May 14, 2015
Abate by
Jun 9, 2015
Penalty
Initial $0 · Current $0

Hazardous substances 1520

29 CFR 1910.134(f)(1): The employer did not ensure that employee(s) required to use a tight-fitting facepiece respirator passed the appropriate qualitative fit test (QLFT) or quantitative fit test (QNFT):     1.) On or about February 10, 2015, the employer failed to ensure employees who were required to wear a dust mask during plasma cutting operations were fit tested to determine if the respirator seal was adequate.  Employees were exposed to hazards from iron oxide plasma cutting operations.
Recent events (1)
  • — Z (S) $0

1910.134 K01

Serious Gravity 1 1 instance 1 exposed
Issued
May 14, 2015
Abate by
Jun 9, 2015
Penalty
Initial $0 · Current $0

Hazardous substances 1520

29 CFR 1910.134(k)(1): The employer shall ensure that each employee can demonstrate knowledge of at least the following:     1.) On or about February 10 2015, the employer failed to provide training on the necessity of a respirator, how to recognize the limitations and capabilities of a respirator, and how to inspect and maintain a respirator to employees who were required to wear dust mask respirators while performing plasma cutting operations.
Recent events (1)
  • — Z (S) $0

View Superior Wire and Metal Spec.'s full OSHA safety record →

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 340372226.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.