OSHA Inspection: C & S CUSTOM CABINETS

Issued

May 29, 2015

Abate by

Jun 17, 2015

Penalty

Initial $3,500 · Current $2,625 Reduced

General-duty citation text

29 CFR 1910.147(c)(1): The employer did not establish a program consisting of an energy control procedure, employee training and periodic inspections to ensure that before any employee performed any servicing or maintenance on a machine or equipment where the unexpected energizing, startup or release of stored energy could occur and cause injury, the machine or equipment shall be isolated from the energy source and rendered inoperative:  a)   At the facility: The employer did not establish a Lockout/Tagout Program consisting of energy control procedures, employee training and periodic inspections for those employees performing service and maintenance to machines including but not limited to the OptiSaw 2 and Thermwood CNC machines, on or about February 17, 2015.                                        ABATEMENT CERTIFICATION IS REQUIRED FOR THIS VIOLATION.

Issued

May 29, 2015

Abate by

Jul 16, 2015

Penalty

Initial $3,500 · Current $2,625 Reduced

General-duty citation text

29 CFR 1910.107(b)(5)(iv): Space within the spray booth on the downstream and upstream sides of filters were not protected with approved automatic sprinklers:  a) In the Production Area:  The open face spray booth was not equipped with an approved automatic sprinkler. Employees were exposed to potential fire hazards on or about February 17, 2015.                        ABATEMENT CERTIFICATION REQUIRED FOR THIS VIOLATION.