Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,992Inspections Most recent open 2026-07-18 Last loaded 2026-07-22

OSHA Inspection: CULIN & COLELLA INC.

Referral inspection · Safety discipline

On , OSHA opened a referral safety inspection of CULIN & COLELLA INC. in 632 CENTER AVENUE, MAMARONECK, NY 10543 (NAICS 321918). OSHA activity number 340410166.

What this inspection record means

OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch Culin & Colella INC. — free Get an email when a new federal OSHA severe-injury report for Culin & Colella INC. is published. One employer, no account, unsubscribe in one click.
Site address
632 CENTER AVENUE
City
MAMARONECK
State
NY
ZIP
10543
Mailing
632 CENTER AVENUE, MAMARONECK, NY 10543
Inspection type
Referral (C)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
321918
Employees
11
Ownership type
A

4 citations on file for this inspection.

1910.213 P04

Other-than-serious 1 instance 3 exposed
Issued
Jul 30, 2015
Abate by
Aug 25, 2015
Penalty
Initial $1,600 · Current $0 Reduced
29 CFR 1910.213(p)(4): Belt sanding machinery was not provided with a guard at each nip point where the sanding belt ran onto a pulley, to prevent the operator's hands or fingers from coming into contact with nip points. The unused run of the sanding belt was not guarded against accidental contact:    On or about 2/18/15    Location: Shop, 632 Center Avenue, Mamaroneck, NY 10543    a)  The horizontal table belt sander did not have a guard covering the belt pulleys or the unused/rear run of the belt.
Recent events (2)
  • — I (O) $0
  • — Z (S) $1600

1910.303 B01

Serious Gravity 1 1 instance 3 exposed
Issued
Jul 30, 2015
Abate by
Aug 25, 2015
Penalty
Initial $1,200 · Current $700 Reduced
29 CFR 1910.303(b)(1): Electrical equipment was not free from recognized hazards that were likely to cause death or serious physical harm to employees:    On or about 2/18/15    Location: Shop, 632 Center Avenue, Mamaroneck, NY 10543    a) The electrical cord male plug was missing on the DeWalt miter saw, the cord was spliced and wrapped with electrical tape directly to a orange extension cord that had the female plug removed.
Recent events (2)
  • — I (S) $700
  • — Z (S) $1200

1910.303 B02

Serious Gravity 1 1 instance 4 exposed
Issued
Jul 30, 2015
Abate by
Aug 25, 2015
Penalty
Initial $1,200 · Current $700 Reduced
29 CFR 1910.303(b)(2): Listed or labeled electrical equipment was not used or installed in accordance with instructions included in the listing or labeling:    On or about 2/18/15    Location: Shop, 632 Center Avenue, Mamaroneck, NY 10543    a) A quad outlet metal "J" box was used at the end of a extension cord as an temporary wiring distribution point. The box is listed/labeled only to be used as part of permanent building wiring attached to a structural member.
Recent events (2)
  • — I (S) $700
  • — Z (S) $1200

1910.305 G01 IV A

Serious Gravity 1 1 instance 11 exposed
Issued
Jul 30, 2015
Abate by
Aug 25, 2015
Penalty
Initial $1,200 · Current $700 Reduced
29 CFR 1910.305(g)(1)(iv)(A): Flexible cords and/or cables were used as a substitute for the fixed wiring of a structure:    On or about 2/18/15    Location: Shop, 632 Center Avenue, Mamaroneck, NY 10543     a) Extension cords were used in place of permanent/fixed building wiring to power equipment. The cords were hung across the ceiling supported and attached to metal piping and used as power drops.
Recent events (2)
  • — I (S) $700
  • — Z (S) $1200

View Culin & Colella INC.'s full OSHA safety record →

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 340410166.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.