Safety Incidents OSHA Severe Injury Reports · 2015–2025
3,913,242Inspections Most recent open 2026-07-13 Last loaded 2026-07-17

OSHA Inspection: PRECISION PHOTO-FAB, INC.

Referral inspection · Health discipline

On , OSHA opened a referral health inspection of PRECISION PHOTO-FAB, INC. in 51 NORTH GATES AVENUE, LACKAWANNA, NY 14218 (NAICS 332710). OSHA activity number 340552967.

Watch Precision Photo-Fab, INC. — free Get an email when a new federal OSHA severe-injury report for Precision Photo-Fab, INC. is published. One employer, no account, unsubscribe in one click.
Site address
51 NORTH GATES AVENUE
City
LACKAWANNA
State
NY
ZIP
14218
Mailing
51 NORTH GATES AVENUE, LACKAWANNA, NY 14218
Inspection type
Referral (C)
Scope
Partial (B)
Discipline
Health
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
332710
Employees
60
Ownership type
A

5 citations on file for this inspection.

1910.134 C01

Serious Gravity 5 1 instance 2 exposed
Issued
Penalty
Initial $3500.00 · Current $2100.00 Reduced
29 CFR 1910.134(c)(1): The employer did not establish and implement a written respiratory protection program with worksite-specific procedures in any workplace where respirators are necessary to protect the health of the employee or whenever respirators are required by the employer:    a) Facility - On or about 04/14/15, the employer required employees to wear MSA-Comfo Classic half-face air-purifying respirators with organic vapor cartridges while performing spray coating.  The employer did not establish and implement a written respiratory protection program.    NO ABATEMENT CERTIFICATION REQUIRED
Recent events (2)
  • — I (S) $2100
  • — Z (S) $3500

1910.134 E01

Serious Gravity 5 1 instance 2 exposed
Issued
Penalty
Initial $0.00 · Current $0.00
29 CFR 1910.134(e)(1): The employer did not provide a medical evaluation to determine the employee's ability to use a respirator, before the employee was fit tested or required to use the respirator in the workplace: Note:  The employer may discontinue an employee's medical evaluations when the employee is no longer required to use a respirator.  a)  Facility - On or about 04/14/15, the employer required employees to wear MSA Comfo Twin-Cartridge air purifying half-face respirators with organic vapor cartridges while performing spray coating.  Employees were not provided a medical evaluation.  NO ABATEMENT CERTIFICATION REQUIRED
Recent events (2)
  • — I (S) $0
  • — Z (S) $0

1910.134 F01

Serious Gravity 5 1 instance 2 exposed
Issued
Penalty
Initial $0.00 · Current $0.00
29 CFR 1910.134(f)(1): The employer did not ensure that employee(s) required to use a tight-fitting facepiece respirator passed the appropriate qualitative fit test (QLFT) or quantitative fit test (QNFT):  a)  Facility - On or about 04/14/15, the employer required employees to wear MSA Comfo Twin-Cartridge half-face air-purifying respirators with organic vapor cartridges while performing spray coating.  Employees were not provided a qualitative fit test (QLFT) or quantitative fit test (QNFT).  NO ABATEMENT CERTIFICATION REQUIRED
Recent events (2)
  • — I (S) $0
  • — Z (S) $0

1910.1000 A

Serious Gravity 5 1 instance 2 exposed
Issued
Abate by
Penalty
Initial $3500.00 · Current $2100.00 Reduced
29 CFR 1910.1000(a): Table Z-1. An employee's exposure to any substance listed in Table Z-1, in any 8-hour work shift of a 40-hour work week exceeded the 8-hour time weighted average limit given for that substance in the table.    1) Spray area - On or about 05/05/15, employees were exposed to Nickel at an 8-hour time weighted average (TWA) level of 1.4 mg/m3, approximately 1.3 times the permissible exposure limit (PEL) of 1.0 mg/m3.  The exposure calculations are based on results obtained over 410 minutes of sampling with a zero increment used for the 70 minutes not sampled.     ABATEMENT DOCUMENTATION REQUIRED
Recent events (2)
  • — I (S) $2100
  • — Z (S) $3500

1910.1000 E

Serious Gravity 5 1 instance 2 exposed
Issued
Abate by
Penalty
Initial $0.00 · Current $0.00
29 CFR 1910.1000(e): Feasible administrative or engineering controls were not determined and implemented to achieve compliance with the limits prescribed in 29 CFR 1910.1000(a) through (d):  1) Spray area - On or about 05/05/15, employees were exposed to Nickel at an 8-hour time weighted average (TWA) level of 1.4 mg/m3, approximately 1.3 times the permissible exposure limit (PEL) of 1.0 mg/m3.  The exposure calculations are based on results obtained over 410 minutes of sampling with a zero increment used for the 70 minutes not sampled.   Feasible engineering controls were not implemented.   ABATEMENT DOCUMENTATION REQUIRED
Recent events (2)
  • — I (S) $0
  • — Z (S) $0

View PRECISION PHOTO-FAB, INC.'s full OSHA safety record →

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 340552967.