Safety Incidents OSHA Severe Injury Reports · 2015–2025
3,913,242Inspections Most recent open 2026-07-13 Last loaded 2026-07-17

OSHA Inspection: PRECISION PHOTO-FAB INC.

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of PRECISION PHOTO-FAB INC. in 4020 JEFFERY BOULEVARD, BUFFALO, NY 14219 (NAICS 332710). OSHA activity number 346156409.

Watch Precision Photo-Fab INC. — free Get an email when a new federal OSHA severe-injury report for Precision Photo-Fab INC. is published. One employer, no account, unsubscribe in one click.
Site address
4020 JEFFERY BOULEVARD
City
BUFFALO
State
NY
ZIP
14219
Mailing
4020 JEFFERY BOULEVARD, BUFFALO, NY 14219
Inspection type
Planned (H)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
332710
Employees
44
Ownership type
A

7 citations on file for this inspection.

1910.28 B01 I

Serious Gravity 5 1 instance 3 exposed
Issued
Abate by
Penalty
Initial $4931.00 · Current $3000.00 Reduced
29 CFR  1910.28(b)(1)(i): The employer did not ensure that each employee on a walking-working surface with an unprotected side or edge that was 4 feet (1.2 m) or more above a lower level was protected from falling by one or more of the following:  Guardrail systems, safety net systems, or personal fall arrest systems:   a) On or about 08/18/2022 in the wastewater treatment area, employees who work in the area are exposed to a fall hazard of approximately 54 inches at the unprotected edge of the pit where the wastewater tanks are located.  b) On or about 08/18/2022 in the sludge press room, employees are exposed to a fall hazard of approximately over 6 feet when employees have to stand on a platform to clean the plates of the J-Press into an unguarded floor opening.  ABATEMENT DOCUMENTATION REQUIRED
Recent events (2)
  • — I (S) $3000
  • — Z (S) $4931

1910.106 E06 I

Serious Gravity 1 1 instance 1 exposed
Issued
Abate by
Penalty
Initial $3698.00 · Current $2500.00 Reduced
29 CFR 1910.106(e)(6)(i): Adequate precautions were not taken to prevent the ignition of flammable vapors from sources such as open flames; lightning; smoking; cutting and welding; hot surfaces; frictional heat; static, electrical, and mechanical sparks; spontaneous ignition, including heat-producing chemical reactions; and radiant heat:  a) On or about 08/18/2022, in the Bench area at 51 North Gates Avenue, when employees dispense Acetone from 5 lbs. container to smaller containers, employees did not ground the drum to remove static electricity, exposing them to fire hazards.  ABATEMENT CERTIFICATION REQUIRED
Recent events (2)
  • — I (S) $2500
  • — Z (S) $3698

1910.106 E06 II

Serious Gravity 1 1 instance 1 exposed
Issued
Abate by
Penalty
Initial $0.00 · Current $0.00
29 CFR 1910.106(e)(6)(ii): Category 1 or 2 flammable liquids, or Category 3 flammable liquids with a flashpoint below 100 °F (37.8 °C), were dispensed into containers without the nozzle and container being electrically interconnected.  a) On or about 08/18/2022, in the bench area at 51 North Gates Avenue, when employees dispense Acetone from 5 lbs. container to smaller containers, employees did not use bonding wires to electrically interconnect the drums and containers together, exposing them to fire hazards.   ABATEMENT CERTIFICATION REQUIRED
Recent events (2)
  • — I (S) $0
  • — Z (S) $0

1910.147 C04 I

Serious Gravity 5 1 instance 1 exposed
Issued
Abate by
Penalty
Initial $6164.00 · Current $4000.00 Reduced
29 CFR 1910.147(c)(4)(i): Procedures were not developed, documented and utilized for the control of potentially hazardous energy when employees were engaged in activities covered by this section:  a) On or about 08/18/2022, in the shop area located at 51 North Gates Avenue, Lockout/Tagout (LOTO) procedures were not utilized when setting up the press break exposing employees to the unexpected startup of the press break.  ABATEMENT CERTIFICATION REQUIRED
Recent events (2)
  • — I (S) $4000
  • — Z (S) $6164

1910.147 C07 I A

Serious Gravity 5 1 instance 2 exposed
Issued
Abate by
Penalty
Initial $0.00 · Current $0.00
29 CFR  1910.147(c)(7)(i)(A): Each authorized employee had not received training in the recognition of applicable hazardous energy sources, the type and magnitude of the energy available in the workplace, and the methods and means necessary for energy isolation and control:  a) On or about 08/18/2022, throughout establishment, employer did not provide Lockout/Tagout(LOTO) training to authorized employees that performed maintenance and servicing activities on machines such as, but not limited to: press brakes, belt sanders, electrical equipment.   ABATEMENT CERTIFICATION REQUIRED
Recent events (2)
  • — I (S) $0
  • — Z (S) $0

1910.151 C

Serious Gravity 5 1 instance 3 exposed
Issued
Abate by
Penalty
Initial $4931.00 · Current $3000.00 Reduced
29 CFR 1910.151(c): Where employees were exposed to injurious corrosive materials, suitable facilities for quick drenching or flushing of the eyes and body were not provided within the work area for immediate emergency use:  a) On or about 08/18/2022, in the Wet Room, where employees dispense corrosive chemicals such as but not limited to Muriatic Acid, there is not an eye wash and shower station in close proximity where the chemicals were being handled in case of an emergency.  ABATEMENT CERTIFICATION REQUIRED
Recent events (2)
  • — I (S) $3000
  • — Z (S) $4931

1904.41 A02

Other-than-serious 1 instance 48 exposed
Issued
Abate by
Penalty
Initial $1450.00 · Current $500.00 Reduced
29 CFR  1904.41(a)(2): Annual electronic submission of OSHA Form 300A Summary of Work-Related Injuries and Illnesses by establishments with 20 or more employees but fewer than 250 employees in designated industries. If your establishment had 20 or more employees but fewer than 250 employees at any time during the previous calendar year, and your establishment is classified in an industry listed in appendix A to subpart E of this part, then you must electronically submit information from OSHA Form 300A Summary of Work-Related Injuries and Illnesses to OSHA or OSHA's designee. You must submit the information once a year, no later than the date listed in paragraph (c) of this section of the year after the calendar year covered by the form:  a) Located at the Precision Photo-Fab Inc. DBA Switzer: On or about 08/18/2022, the employer failed during calendar year 2021, to electronically submit information from their OSHA Form 300A or equivalent by 03/02/2022. The establishment employed 48 employees and is classified 332812 during calendar year 2021.  ABATEMENT CERTIFICATION REQUIRED
Recent events (2)
  • — I (O) $500
  • — Z (O) $1450

View PRECISION PHOTO-FAB INC.'s full OSHA safety record →

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 346156409.