KANEOHE, HI —
OSHA Inspection: WATTS CONSTRUCTORS
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of WATTS CONSTRUCTORS in MV-22 HANGAR INFRASTRUCTURE, KANEOHE, HI 96744 (NAICS 236220). OSHA activity number 340556430.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- WATTS CONSTRUCTORS
- Site address
- MV-22 HANGAR INFRASTRUCTURE
- City
- KANEOHE
- State
- HI
- ZIP
- 96744
- Mailing
- 737 BISHOP STREET SUITE 2900, HONOLULU, HI 96813
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Complete (A)
- Discipline
- Safety
- Advance notice
- No
- Union status
- A
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 236220
- Employees
- 200
- Ownership type
- A
Citations
6 citations on file for this inspection.
1926.351 E
- Issued
- May 20, 2015
- Abate by
- May 29, 2015
- Penalty
- Initial $2,295 · Current $0 Reduced
General-duty citation text
29 CFR 1926.351(e): Arc welding or cutting operation(s) were not shielded by noncombustible or flame proof screens to protect employees and other persons working in the vicinity from the direct rays of the arc: a) On April 15, 2015, employees were arc welding on the ground floor of the hangar facility without the use of arc protective screens, exposing other employees working in the area to the infrared radiation eye hazards.
Recent events (2)
- — I (S) $0
- — Z (S) $2295
1926.651 F
- Issued
- May 20, 2015
- Abate by
- Jun 2, 2015
- Penalty
- Initial $2,295 · Current $0 Reduced
General-duty citation text
29 CFR 1926.651(f): A warning system such as barricades, hand or mechanical signals, or stop logs was not utilized when mobile equipment was operated adjacent to an excavation, when such equipment was required to approach the edge of an excavation: a) On April 15, 2015, on the West side of the Utility Building, employees were operating an aerial lift next to and directly above an excavation that was not protected.
Recent events (2)
- — I (S) $0
- — Z (S) $2295
1926.1425 E02
- Issued
- May 20, 2015
- Abate by
- May 29, 2015
- Penalty
- Initial $2,295 · Current $0 Reduced
General-duty citation text
29 CFR 1926.1425(e)(2): During lift operations the employer did not prevent employees from getting directly under the load. a) On April 15, 2015, the crane was in operation lifting metal roofing pieces up to Iron workers, without restricting employees from working below the load area.
Recent events (2)
- — I (S) $0
- — Z (S) $2295
1910.1200 G01
- Issued
- May 20, 2015
- Abate by
- May 29, 2015
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1910.1200(g)(1): The employer did not have a material safety data sheet for each hazardous chemical in use: a) On April 15, 2015, the employer did not have a copy of the Data Sheet for the chlorine tablets.
Recent events (2)
- — I (O) $0
- — Z (O) $0
1926.405 A02 II I
- Issued
- May 20, 2015
- Abate by
- May 29, 2015
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1926.405(a)(2)(ii)(I): Flexible cords and cables shall be protected from damage: a) On April 15, 2015, a Miller III arc welder was placed directly on top of two 110 VAC electrical cords and had damaged the outer insulation.
Recent events (2)
- — I (O) $0
- — Z (O) $0
1926.501 B04 II
- Issued
- May 20, 2015
- Abate by
- Jun 2, 2015
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1926.501(b)(4)(ii): Each employee on a walking/working surface was not protected from tripping in or stepping into or through holes (including skylights) by covers: a) On April 15, 2015, employees were walking in the new ramp area of the construction site where more than 50 holes, were drilled into the base pavement that were 6" in diameter and 5" deep and were not covered or marked.
Recent events (2)
- — I (O) $0
- — Z (O) $0
More inspections at Watts Constructors
View Watts Constructors's full OSHA safety record →
More inspections in this industry (NAICS 236220)
More inspections in HI
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 340556430.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.