MENTOR, OH —
OSHA Inspection: APOLLO MANUFACTURING COMPANY, LLC
Complaint inspection · Health discipline
At a glance
On , OSHA opened a complaint health inspection of APOLLO MANUFACTURING COMPANY, LLC in 7911 ENTERPRISE DR., MENTOR, OH 44060 (NAICS 332212). OSHA activity number 340661230.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- APOLLO MANUFACTURING COMPANY, LLC
- Site address
- 7911 ENTERPRISE DR.
- City
- MENTOR
- State
- OH
- ZIP
- 44060
- Mailing
- 7911 ENTERPRISE DR., MENTOR, OH 44060
What kind of inspection was it?
- Inspection type
- Complaint (B)
- Scope
- Partial (B)
- Discipline
- Health
- Advance notice
- No
- Union status
- B
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 332212
- Employees
- 40
- Ownership type
- A
Citations
2 citations on file for this inspection.
1910.219 C02 I
- Issued
- Jul 17, 2015
- Abate by
- Aug 6, 2015
- Penalty
- Initial $2,975 · Current $2,083 Reduced
General-duty citation text
29 CFR 1910.219(c)(2)(i): All exposed part(s) of horizontal shafting seven (7) feet or less from floor or working platform were not protected by stationary casing(s) enclosing shafting completely or by trough(s) enclosing sides and top or sides and bottom of shafting: On or about May 28, 2015, the exposed drive shaft for the grinding wheel on the right side of the Monocet Cincinnati tool shaper, was open exposing workers to a rotating part.
Recent events (2)
- — I (S) $2082.5
- — Z (S) $2975
1910.219 E03 I
- Issued
- Jul 17, 2015
- Abate by
- Aug 6, 2015
- Penalty
- Initial $2,975 · Current $2,083 Reduced
General-duty citation text
29 CFR 1910.219(e)(3)(i): Vertical or inclined belt(s) were not enclosed by guard(s) conforming to the requirements specified at 29 CFR 1910.219(m) and (o): On or about May 28, 2015, the drive belt used to spin the tool chuck for the Monocet Cincinnati tool shaper, approximately 4 feet from ground level, was open exposing workers to an ingoing nip point.
Recent events (2)
- — I (S) $2082.5
- — Z (S) $2975
More inspections in this industry (NAICS 332212)
More inspections in OH
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 340661230.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.