BELLBROOK, OH ·
OSHA Inspection: DANIEL STIDHAM ROOFING AND SIDING
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of DANIEL STIDHAM ROOFING AND SIDING in 4030 W. FRANKLIN ST., BELLBROOK, OH 45305 (NAICS 238160). OSHA activity number 340662931.
OSHA opens inspections for many reasons: routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- DANIEL STIDHAM ROOFING AND SIDING
- Site address
- 4030 W. FRANKLIN ST.
- City
- BELLBROOK
- State
- OH
- ZIP
- 45305
- Mailing
- 37 YORK STREET, DAYTON, OH 45403
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- Non-union (B)
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 238160
- Employees
- 7
- Ownership type
- Private (A)
Citations
2 citations on file for this inspection.
1926.501 B10
- Issued
- Sep 2, 2015
- Abate by
- Sep 29, 2015
- Penalty
- Initial $2,800 · Current $2,800
General-duty citation text
29 CFR 1926.501(b)(10): "Roofing work on Low-slope roofs." Except as otherwise provided in paragraph (b) of this section, each employee engaged in roofing activities on low-slope roofs, with unprotected sides and edges 6 feet (1.8 m) or more above lower levels shall be protected from falling by guardrail systems, safety net systems, personal fall arrest systems, or a combination of warning line system and guardrail system, warning line system and safety net system, or warning line system and personal fall arrest system, or warning line system and safety monitoring system. Or, on roofs 50-feet (15.25 m) or less in width (see Appendix A to subpart M of this part), the use of a safety monitoring system alone [i.e. without the warning line system] is permitted. Workers were observed engaged in commercial construction activities re-roofing an existing structure. Workers were exposed to potential fall hazards from heights between 9.1 feet and 19.5 feet in that a proper fall protection system was not utilized.
Recent events (1)
- · Z (S) $2800
1926.503 A01
- Issued
- Sep 2, 2015
- Abate by
- Sep 29, 2015
- Penalty
- Initial $2,000 · Current $2,000
General-duty citation text
29 CFR 1926.503(a)(1): The employer shall provide a training program for each employee who might be exposed to fall hazards. The program shall enable each employee to recognize the hazards of falling and shall train each employee in the procedures to be followed in order to minimize these hazards. Workers were observed engaged in commercial construction activities re-roofing an existing structure. Workers were exposed to potential fall hazards from heights between 9.1 feet and 19.5 feet in that the workers were not properly trained in fall protection criteria.
Recent events (1)
- · Z (S) $2000
More inspections in this industry (NAICS 238160)
More inspections in OH
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). OSHA publishes its own view of this case as inspection number 340662931.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.