Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,992Inspections Most recent open 2026-07-18 Last loaded 2026-07-22

OSHA Inspection: RIGGS ROUSTABOUT & HOTSHOT SERVICES, INC.

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of RIGGS ROUSTABOUT & HOTSHOT SERVICES, INC. in ROSEY HAVENSTRITE 2-30H, SEC 3-6N-7W GRADY CTY, NINNEKAH, OK 73067 (NAICS 237120). OSHA activity number 340695907.

What this inspection record means

OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch Riggs Roustabout & Hotshot Services, INC. — free Get an email when a new federal OSHA severe-injury report for Riggs Roustabout & Hotshot Services, INC. is published. One employer, no account, unsubscribe in one click.
Site address
ROSEY HAVENSTRITE 2-30H, SEC 3-6N-7W GRADY CTY
City
NINNEKAH
State
OK
ZIP
73067
Mailing
501 AVE J, BEAVER, OK 73932
Inspection type
Planned (H)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
237120
Employees
3
Ownership type
A

5 citations on file for this inspection.

1926.21 B02

Serious Gravity 1 1 instance 2 exposed
Issued
Jun 29, 2015
Abate by
Jul 22, 2015
Penalty
Initial $1,020 · Current $612 Reduced
29 CFR 1926.21(b)(2): The employer did not instruct each employee in the recognition and avoidance of unsafe condition(s) and the regulation(s) applicable to his work environment to control or eliminate any hazard(s) or other exposure to illness or injury:  Well head area: On or about June 4, 2015, employees installing an oil/gas well's flow lines worked in a trench.  The employees had not been trained on excavation hazards and their prevention.  This exposed the employees to the hazard of being struck by falling soil.
Recent events (2)
  • — I (S) $612
  • — Z (S) $1020

1926.651 J02

Serious Gravity 1 1 instance 2 exposed
Issued
Jun 29, 2015
Abate by
Jul 22, 2015
Penalty
Initial $0 · Current $0
29 CFR 1926.651(j)(2): Protection was not provided by placing and keeping excavated or other materials or equipment at least 2 feet (.61m) from the edge of excavations, or by the use of retaining devices that were sufficient to prevent materials or equipment from falling or rolling into excavations, or by a combination of both if necessary:  Well head area: On or about June 4, 2015, employees installing an oil/gas well's flow lines worked in a trench.  The spoil bank on the north end of the trench sat on the edge of the trench walls.  This exposed the employees to the hazard of being struck by falling soil.
Recent events (2)
  • — I (S) $0
  • — Z (S) $0

1926.652 A01

Serious Gravity 1 1 instance 2 exposed
Issued
Jun 29, 2015
Abate by
Jul 22, 2015
Penalty
Initial $0 · Current $0
29 CFR 1926.652(a)(1): Each employee in an excavation was not protected from cave-ins by an adequate protective system designed in accordance with paragraph (b) or (c) of this section except when:  Well head area: On or about June 4, 2015, employees installing an oil/gas well's flow lines worked in a trench.  No protective system was provided for employees in the 5 feet and deeper trench .  This exposed the employees to the hazard of being struck by falling soil.
Recent events (2)
  • — I (S) $0
  • — Z (S) $0

1926.404 B01 I

Serious Gravity 5 1 instance 2 exposed
Issued
Jun 29, 2015
Abate by
Jul 8, 2015
Penalty
Initial $1,360 · Current $816 Reduced
29 CFR 1926.404(b)(1)(i): Employer did not use either ground fault circuit interrupters as specified in paragraph (b)(1)(ii) of this section, or an assured equipment grounding conductor program as specified in paragraph (b)(1)(iii) of this section to protect employees on construction sites:  Well area:  On or about June 4, 2015, and time prior to, employees installing an oil/gas well flow lines used electric handtools powered from a truck mounted generator through a cordset.  No ground fault protection was used exposing the employees to the hazard of electrical shock.
Recent events (2)
  • — I (S) $816
  • — Z (S) $1360

1926.416 E01

Serious Gravity 5 1 instance 2 exposed
Issued
Jun 29, 2015
Abate by
Jul 1, 2015
Penalty
Initial $1,360 · Current $816 Reduced
29 CFR 1926.416(e)(1): Worn or frayed electric cords or cables were used:  Well area:  On or about June 4, 2015, and time prior to, employees installing an oil/gas well flow lines used electric handtools powered from a truck mounted generator through a cordset. The cordset was damaged and an electric handtool had a severely damaged attachment cord exposing the employees to the hazard of electrical shock.
Recent events (2)
  • — I (S) $816
  • — Z (S) $1360

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 340695907.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.