Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,992Inspections Most recent open 2026-07-18 Last loaded 2026-07-22

OSHA Inspection: UNCOMMON ANGLES, INC.

Complaint inspection · Safety discipline

On , OSHA opened a complaint safety inspection of UNCOMMON ANGLES, INC. in 105 ISABELL CT., BUENA VISTA, CO 81211 (NAICS 238120). OSHA activity number 340701408.

What this inspection record means

OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch Uncommon Angles, INC. — free Get an email when a new federal OSHA severe-injury report for Uncommon Angles, INC. is published. One employer, no account, unsubscribe in one click.
Site address
105 ISABELL CT.
City
BUENA VISTA
State
CO
ZIP
81211
Mailing
29015 C/R 330 P.O. BOX 1253, BUENA VISTA, CO 81211
Inspection type
Complaint (B)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
238120
Employees
5
Ownership type
A

7 citations on file for this inspection.

1926.760 B03

Serious Gravity 5 1 instance 1 exposed
Issued
Jul 31, 2015
Abate by
Aug 19, 2015
Penalty
Initial $2,000 · Current $1,200 Reduced
29 CFR 1926.760(b)(3): Each connector working at heights over 15 and up to 30 feet above a lower level, was not provided with a personal fall arrest system, positioning device system or fall restraint system and wear the equipment necessary to be able to be tied off; or was not provided with other means of protection from fall hazards in accordance with paragraph (a)(1) of this section.      (a) On or about June 9, 2015, the employees were exposed to injuries from falls approximately 20.0 feet while not being provided with a means of fall protection from fall hazards.      Abatement Note: Abatement certification and documentation are required for this item (see enclosed "Certification of Corrective Action Worksheet").
Recent events (2)
  • — I (S) $1200
  • — Z (S) $2000

1926.602 C01 VIII

Deleted Serious Gravity 5 1 instance 1 exposed
Issued
Jul 31, 2015
Abate by
Aug 19, 2015
Penalty
Initial $2,000 · Current $0 Reduced
29 CFR 1926.602(c)(1)(viii): A lift truck, equipped with vertical only, or vertical and horizontal controls elevatable with the lifting carriage or forks for lifting personnel, did not have the following precautions to include use of a safety platform firmly secured to the lifting carriage and/or forks:  a) On or about June 9, 2015, the employer did not secure the forks to the platform attached to the Lull Telescopic Forklift.  Abatement Note: Abatement certification and documentation are required for this item (see enclosed "Certification of Corrective Action Worksheet").
Recent events (2)
  • — I (S) $0
  • — Z (S) $2000

1926.451 G04 I

Serious Gravity 5 1 instance 1 exposed
Issued
Jul 31, 2015
Abate by
Aug 19, 2015
Penalty
Initial $2,000 · Current $1,200 Reduced
29 CFR 1926.451(g)(4)(i): Guardrail systems were not installed along all open sides and ends of platforms before being released for use by employees other than erection/dismantling crews:      (a) On or about June 9, 2015, the employees were exposed to injuries from falls approximately 20.0  feet while on a platform which was missing the front guard rails.      Abatement Note: Abatement certification and documentation are required for this item (see enclosed "Certification of Corrective Action Worksheet").
Recent events (2)
  • — I (S) $1200
  • — Z (S) $2000

1926.451 F03

Serious Gravity 5 1 instance 1 exposed
Issued
Jul 31, 2015
Abate by
Aug 19, 2015
Penalty
Initial $2,000 · Current $1,200 Reduced
29 CFR 1926.451(f)(3): Scaffolds and scaffold components were not inspected for visible defects by a competent person before each work shift, and after any occurrence which could affect a scaffold's structural integrity:    a) On or about June 9, 2015, the employer did not inspect the scaffold prior to each work shift to ensure the scaffolds structural integrity.    Abatement Note: Abatement certification and documentation are required for this item (see enclosed "Certification of Corrective Action Worksheet").
Recent events (2)
  • — I (S) $1200
  • — Z (S) $2000

1926.454 A

Serious Gravity 5 1 instance 1 exposed
Issued
Jul 31, 2015
Abate by
Aug 19, 2015
Penalty
Initial $0 · Current $0
29 CFR 1926.454(a): The employer did not have each employee who performed work while on a scaffold trained by a person qualified in the subject matter to recognize the hazards associated with the type of scaffold being used and to understand the procedures to control or minimize those hazards.  a) On or about June 9, 2015, the employer did not trained employees to recognize hazards associated with the scaffold.  Abatement Note: Abatement certification and documentation are required for this item (see enclosed "Certification of Corrective Action Worksheet").
Recent events (2)
  • — I (S) $0
  • — Z (S) $0

1926.451 E07

Serious Gravity 5 1 instance 1 exposed
Issued
Jul 31, 2015
Abate by
Aug 19, 2015
Penalty
Initial $0 · Current $0
29 CFR 1926.451(e)(7): Steps and rungs of ladder and stairway type access did not line up vertically with each other between rest platforms:  (a) On or about June 9, 2015, employees accessed a scaffold platform located 20 feet above ground utilizing integral prefabricated scaffold access frames that did not line up vertically.  Abatement Note: Abatement certification and documentation are required for this item (see enclosed "Certification of Corrective Action Worksheet").
Recent events (2)
  • — I (S) $0
  • — Z (S) $0

1926.100 A

Serious Gravity 1 5 instances 1 exposed
Issued
Jul 31, 2015
Abate by
Aug 19, 2015
Penalty
Initial $1,200 · Current $1,000 Reduced
29 CFR 1926.100(a): Employees working in areas where there was a possible danger of head injury from impact, or falling or flying objects, or from electrical shock and burns, were not protected by protective helmets:    a) On or about June 9, 2015, the employer did not protect employees from struck-by hazards due to work being conducted on a platform attached to a Lull Telescopic Forklift and a scaffold at approximately 20 feet.  Employees working below the scaffold and platform did not have protective helmets.    Abatement Note: Abatement certification and documentation are required for this item (see enclosed "Certification of Corrective Action Worksheet").
Recent events (2)
  • — I (S) $1000
  • — Z (S) $1200

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 340701408.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.