OSHA Inspection: MY SIGNATURE LIVING, LLC.

Issued

Aug 10, 2015

Penalty

Initial $1,020 · Current $612 Reduced

General-duty citation text

29 CFR 1910.22(a)(1): All places of employment, passageways, storerooms or service rooms were not kept clean and orderly or in a sanitary condition:  a) In the fabrication area, on top of, in between and underneath equipment as well as the floor, a wood dusting and accumulated saw dust piles were observed, on or about June 04, 2015.

Issued

Aug 10, 2015

Penalty

Initial $2,800 · Current $1,680 Reduced

General-duty citation text

29 CFR 1910.213(d)(1): Circular handfed crosscut table saw(s) were not guarded by an automatically adjusting hood which completely enclosed that portion of the saw above the table and above the material being cut:  (a) by employees in the fabrication who were using a Delta and/or Powermatic table saws without guarding, on or about June 04, 2015.

Issued

Aug 10, 2015

Penalty

Initial $2,040 · Current $1,224 Reduced

General-duty citation text

29 CFR 1910.242(b): Compressed air used for cleaning purposes was not reduced to less than 30 p.s.i.:  (a) In the fabrication area, employees used compress air for cleaning cut wood and equipment with a reading of 70 p.s.i. , on or about June 4, 2015.

Issued

Aug 10, 2015

Abate by

Aug 20, 2015

Penalty

Initial $0 · Current $0

General-duty citation text

29 CFR 1910.134(k)(6): The employer did not provide the basic advisory information on respirators, as presented in Appendix D of 29 CFR 1910.134, in written or oral format to employees who wear respirators when such use was not required by the employer:  (a) In the fabrication area, employees were using 3M Tekk Protection 8210 Plus, two straps disposable N95 respirators, while performing cutting, sanding or applying adhesives, on or about June 4, 2015.

Issued

Aug 10, 2015

Penalty

Initial $0 · Current $0

General-duty citation text

29 CFR 1910.304(b)(3)(ii)(C)(3): Each cord set, attachment cap, plug, and receptacle of cord sets, and any equipment connected by cord and plug were not visually inspected before use for external defects, such as deformed or missing pins or insulation damage, and for indications of possible internal damage, and equipment found damaged or defective was not removed from use until repaired:  a)  In the fabrication area, a damage extension cord was being used to provide power to the dust collection system for the Delta Slider 3200 table saw, as observed on June 4, 2015.

Issued

Aug 10, 2015

Abate by

Sep 12, 2015

Penalty

Initial $0 · Current $0

General-duty citation text

29 CFR 1910.1200(e)(1): The employer did not develop, implement, and/or maintain at the workplace a written hazard communication program which describes how the criteria specified in 29 CFR 1910.1200(f), (g), and (h) will be met:  (a) In the fabrication area, employees used chemicals, such as but not limited to, Bostic GlideCote , contact cements, glues and paints, on or about June 4, 2015.