Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,992Inspections Most recent open 2026-07-18 Last loaded 2026-07-22

OSHA Inspection: RUBIO FRAMING, LLC

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of RUBIO FRAMING, LLC in 2710 AVINGTON LANE, SMYRNA, GA 30080 (NAICS 238130). OSHA activity number 340774033.

What this inspection record means

OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch Rubio Framing, LLC — free Get an email when a new federal OSHA severe-injury report for Rubio Framing, LLC is published. One employer, no account, unsubscribe in one click.
Establishment
RUBIO FRAMING, LLC
Site address
2710 AVINGTON LANE
City
SMYRNA
State
GA
ZIP
30080
Mailing
4371 WINTERS CHAPEL ROAD, APT. 2321, DORAVILLE, GA 30360
Inspection type
Planned (H)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
238130
Employees
3
Ownership type
A

3 citations on file for this inspection.

1926.1053 B01

Serious Gravity 5 1 instance 3 exposed
Issued
Aug 6, 2015
Abate by
Aug 18, 2015
Penalty
Initial $2,200 · Current $2,200
29 CFR 1926.1053(b)(1): Portable ladders were used for access to an upper landing surface and the ladder side rails did not extend at least 3 feet (.9 m) above the upper landing surface to which the ladder was used to gain access:  (a) Lot #20 first floor, new townhome construction located at 2710 Avington Lane, Smyrna, GA 30080: Employees were exposed to falls of approximately 11-feet, 11-inches to the lower level while accessing the lower levels and upper levels as the ladder side rails were not extended at least 3-feet past the upper landing surface. The ladder used to access the upper level was 5-feet, 10-inches high and employees had to climb 2x4 cleats to reach the upper level.
Recent events (1)
  • — Z (S) $2200

1926.501 B13

Willful Gravity 10 1 instance 1 exposed
Issued
Aug 6, 2015
Penalty
Initial $15,400 · Current $15,400
29 CFR 1926.501(b)(13): Each employee engaged in residential construction activities 6 feet (1.8 m)  or more above lower levels was not protected by guardrail systems, safety net systems, personal fall arrest systems, or an alternative fall protection measure under another provision of paragraph 1926.501 (b), nor did the employer demonstrate that it is infeasible or creates a greater hazard to use these systems and develop and implement a fall protection plan which meets the requirements of paragraph (k) of section 1926.502:   (a) Front top plate, new townhome construction located at 2710 Avington Lane, Smyrna, GA 30080: Employee was exposed to falls of approximately 24-feet, 3-inches to the lower level while installing 1/2-inch OSB Plywood from a top plate with no fall protection system in place.
Recent events (1)
  • — Z (W) $15400

1926.1053 B04

Repeat Gravity 5 1 instance 3 exposed
Issued
Aug 6, 2015
Abate by
Aug 18, 2015
Penalty
Initial $4,400 · Current $4,400
29 CFR 1926.1053(b)(4): Ladders were not used for the purpose for which they were designed:  (a) Lot #20 first floor, new townhome construction located at 2710 Avington Lane, Smyrna, GA 30080: The employer exposed employees to fall hazards of approximately 5-feet, 10-inches while using a self-supporting ladder to access and egress from upper levels of the residence. The Werner Step Ladder (Model - FS206) which had not been opened and locked into position, was being used in a manner and for a purpose other than what it was designed.   Rubio Framing, LLC was previously cited for a violation of this occupational safety and health standard or its equivalent standard 29 CFR 1926.1053(b)(4), which was contained in OSHA inspection number 899779, citation number 1, item number 2 and was affirmed as a final order on 05/29/2013, with respect to a workplace located at 3025 Eagle Ridge, Roswell, GA 30076.
Recent events (1)
  • — Z (R) $4400

View Rubio Framing, LLC's full OSHA safety record →

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 340774033.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.